The leaching of material from concrete fracture surfaces has an impact on the structural concrete in service, but the number of studies that consider the effect of the coupling of the leaching, fracture geometry and hydraulic processes on concrete fractures is insufficient. In this study, a series of experiments was conducted, and a leaching model proposed, to investigate the mechanism of leaching behavior on the geometric and hydraulic characteristics of concrete fractures. Following the leaching experiment, the evolution of fracture geometric characteristics was observed by a three-dimensional (3D) laser scanning technique, finding that the fracture produces residual leached depth and local uneven leaching, which results in a decrease in roughness. The hydraulic characteristics were then investigated by permeability tests, and it was found that the fracture hydraulic aperture and permeability increase monotonically with leaching time. A simulation of fluid flow in a numerical fracture revealed the effect of residual leached depth and a decrease in roughness on the hydraulic characteristics. Finally, based on the analysis of the chemical composition of the leaching solution, a leaching model of concrete rough fracture surface is proposed and the mechanism of leaching behavior is discussed. These new findings are useful for the understanding of the development of leaching, local to concrete fracture surfaces.
27 March 2026 in Journal of Testing and Evaluation
Seepage leaching increases the risk of spalling in hydraulic tunnel concrete linings. This study first analyzed the spalling model and selected the joint surface (single fracture) between the spalled and unspalled sections of the lining as the research subject. The improved prefabrication method of fractures based on three-dimensional (3D) scanning, 3D modelling, and 3D printing technology was then used to replicate the fracture surfaces of the actual hydraulic tunnel lining, followed by seepage leaching tests. Third, the parameters of the lining spalling model are obtained through improved L-shaped shear tests. The tests revealed an average decrease of 19.2 % in the shear capacity of fractures after seepage leaching. Finally, the safety factor against spalling (SFAS) before and after leaching was quantified based on the spalling model and experimental parameters. The results showed a decrease in SFAS due to leaching. Additionally, this study proposed that the degradation of calcium asperities on fracture surfaces was the cause of the decrease in shear capacity after leaching by analyzing the microscopic leaching of minerals on fracture surfaces in combination with petrographic observations. The aim of this study is to provide theoretical guidance for the maintenance of hydraulic tunnels during operation.