The leaching of material from concrete fracture surfaces has an impact on the structural concrete in service, but the number of studies that consider the effect of the coupling of the leaching, fracture geometry and hydraulic processes on concrete fractures is insufficient. In this study, a series of experiments was conducted, and a leaching model proposed, to investigate the mechanism of leaching behavior on the geometric and hydraulic characteristics of concrete fractures. Following the leaching experiment, the evolution of fracture geometric characteristics was observed by a three-dimensional (3D) laser scanning technique, finding that the fracture produces residual leached depth and local uneven leaching, which results in a decrease in roughness. The hydraulic characteristics were then investigated by permeability tests, and it was found that the fracture hydraulic aperture and permeability increase monotonically with leaching time. A simulation of fluid flow in a numerical fracture revealed the effect of residual leached depth and a decrease in roughness on the hydraulic characteristics. Finally, based on the analysis of the chemical composition of the leaching solution, a leaching model of concrete rough fracture surface is proposed and the mechanism of leaching behavior is discussed. These new findings are useful for the understanding of the development of leaching, local to concrete fracture surfaces.
Traditional cement-based grouting materials have good reinforcement and anti-seepage effects on the surrounding rock under normal conditions, but the grouting effect is not ideal due to problems such as a long setting time, a low stone ratio, and poor crack resistance under high water pressure and in a dynamic water environment. In this study, we aimed to improve the physical properties, chemical properties, and microstructure of a cement-based slurry by forming a hydrogel through its chemical crosslinking with polyvinyl alcohol and boric acid as modifiers for the purpose of improving the permeability resistance of the surrounding rock grouting under high-water-pressure conditions, which can expand the function of traditional building materials. The grouting effect of the modified cementitious material on the surrounding rock was analyzed through indoor tests, the SEM testing of the performance of the modified slurry, the numerical calculation of the seepage field, and the application of the modified slurry in combination with the actual project to verify the water-plugging effect. The research findings demonstrate that (1) the additives boric acid and PVA can significantly speed up the slurry gel time, and the gel time can be controlled within 2–20 min to meet the specification requirements. (2) At a velocity of moving water > 1 m/s, the retention of the solidified modified slurry stone body reaches more than 80%. According to the SEM analysis, the structure of the solidified modified slurry stone body is dense and has good impermeability. (3) According to the numerical calculation analysis, the modified slurry can effectively change the seepage field of the surrounding rock and improve its seepage resistance. The water pressure outside the lining is reduced by 47%, 31%, and 22%, respectively, compared with no slurry, the pure cement slurry, and cement–water-glass grouting, and the indoor test and numerical simulation conclusions are consistent.
In the process of the underground tunnel excavation, a kind of geological condition Necking Region is often encountered. The ground surface inclines very fast, which also leads to the increase of Earth pressure on the excavation face. The determination of the excavation face support pressure is essential to solve the active Earth pressure when the shield passes through the Necking Region. In this paper, based on Horn’s wedge model, considering the influence of surface dip angle on excavation face support pressure, the traditional wedge model was improved. The analytical solution of the ultimate support pressure for the active failure of shield excavation face was derived. To evaluate the quality of the model, the theoretical model was compared with the ultimate bearing pressure of the horizontal surface test. The influence of the ultimate support pressure on the parameters of Nc, Nγ, and Nq was consistent with the results of finite element simulation and existing theories, which verified the rationality of the model. The stability of the excavation face of the Heyan road river crossing tunnel was analyzed by using the improved wedge model. The results show that the mud support pressure considering the slope angle was 36 kPa higher than that without considering the slope angle.