Hai Yang-2 (HY-2) satellite altimeter measurements of significant wave height ( ) are analyzed over the period from 1 October 2011 to 6 December 2014. They are calibrated and validated against in situ buoys and other concurrently operating altimeters: Jason-2, CryoSat-2, and Satellite with Argos and ALtiKa (SARAL). In general, the HY-2 altimeter measurements agree well with buoy measurements, with a bias of −0.22 m and a root-mean-square error (RMSE) of 0.30 m. When the reduced major axis (RMA) regression procedure was applied to the entire period, the RMSE was reduced by 33% to 0.2 m. A further comparison with other satellite altimeters, however, revealed two additional features of HY-2 estimates over this period. First, a noticeable mismatch is present between HY-2 and the other satellite altimeters for high seas ( > 6 m). Second, a jump increase in HY-2 values was detected starting in April 2013, which was associated with the switch to backup status of the HY-2 sensors and the subsequent update of its data processing software. Although reported by previous studies, these two deficiencies had not been accounted for in calibrations. Therefore, the HY-2 wave height records are now subdivided into two phases (time periods pre- and post-April 2013) and a two-branched calibration is proposed for each phase. These revised calibrations, validated throughout the range of significant wave heights of 1–9 m, are expected to improve the practical applicability of HY-2 measurements significantly.

With the improvement in microwave radar technology, spaceborne synthetic aperture radar (SAR) is widely used to observe the tropical cyclone (TC) wind field. Based on European Space Agency Sentinel-1 Interferometric Wide swath (IW) mode imagery, this paper evaluates the correlation between vertical transmitting–horizontal receiving (VH) polarization signals and extreme ocean surface wind speeds (>40 m/s) under strong TC conditions. A geophysical model function (GMF) Sentinel-1 IW mode wind retrieval model after noise removal (S1IW.NR) was proposed, according to the SAR images of nine TCs and collocated stepped frequency microwave radiometer (SFMR) and soil moisture active passive (SMAP) radiometer wind speed measurements. Through curve fitting and regression correction, the new GMF exploits the relationships between VH-polarization normalized radar cross section, incident angle, and wind speed in each sub-swath and covers wind speeds up to 74 m/s. Based on collocated SAR and SFMR measurements of four TCs, the new GMF was validated in the wind speed range from 2 to 53 m/s. Results show that the correlation coefficient, bias, and root mean squared error were 0.89, −0.89 m/s, and 4.13 m/s, respectively, indicating that extreme winds can be retrieved accurately by the new model. In addition, we investigated the relationship between the S1IW.NR wind retrieval bias and the SFMR-measured rain rate. The S1IW.NR model tended to overestimate wind speeds under high rain rates.

While sea spray can significantly impact air–sea heat fluxes, the effect of spray produced by the interaction of wind and waves is not explicitly addressed in current operational numerical models. In the present work, the thermal effects of the sea spray were investigated for an idealized tropical cyclone (TC) through the implementation of different sea spray models into a coupled air–sea–wave numerical system. Wave-Reynolds-dependent and wave-steepness-dependent sea spray models were applied to test the sensitivity of local wind, wave, and ocean fields of this TC system. Results show that while the sensible heat fluxes decreased by up to 231 W m⁻² (364%) and 159 W m⁻² (251%), the latent heat fluxes increased by up to 359 W m⁻² (89%) and 263 W m⁻² (76%) in the simulation period, respectively. This results in an increase of the total heat fluxes by up to 135 W m⁻² (32%) and 123 W m⁻² (30%), respectively. Based on different sea spray models, sea spray decreases the minimum sea level pressure by up to 7 hPa (0.7%) and 8 hPa (0.8%), the maximum wind speed increases by up to 6.1 m s⁻¹ (20%) and 5.7 m s⁻¹ (19%), the maximum significant wave height increases by up to 1.1 m (17%) and 1.6 m (25%), and the minimum sea surface temperature decreases by up to 0.2 °C (0.8%) and 0.15 °C (0.6%), respectively. As the spray has such significant impacts on atmospheric and oceanic environments, it needs to be included in TC forecasting models.