In this work, fatty-acid profiles, including trans fatty acids, in combination with chemometric tools, were applied as a determinant of purity (i.e., adulteration) and provenance (i.e., geographical origin) of cosmetic grade argan oil collected from different regions of Morocco in 2017. The fatty acid profiles obtained by gas chromatography (GC) showed that oleic acid (C18:1) is the most abundant fatty acid, followed by linoleic acid (C18:2) and palmitic acid (C16:0). The content of trans-oleic and trans-linoleic isomers was between 0.02% and 0.03%, while trans-linolenic isomers were between 0.06% and 0.09%. Discriminant analysis (DA) and orthogonal projection to latent structure—discriminant analysis (OPLS-DA) were performed to discriminate between argan oils from Essaouira, Taroudant, Tiznit, Chtouka-Aït Baha and Sidi Ifni. The correct classification rate was highest for argan oil from the Chtouka-Aït Baha province (90.0%) and the lowest for oils from the Sidi Ifni province (14.3%), with an overall correct classification rate of 51.6%. Pairwise comparison using OPLS-DA could predictably differentiate (≥0.92) between the geographical regions with the levels of stearic (C18:0) and arachidic (C20:0) fatty acids accounting for most of the variance. This study shows the feasibility of implementing authenticity criteria for argan oils by including limit values for trans-fatty acids and the ability to discern provenance using fatty acid profiling.

Over the last decade, the two-phase centrifugation system for olive-oil extraction has become dominant in Slovenia. There are many suggestions for the exploitation of two-phase OMW, but among the suggested methods, direct spreading on agricultural land appears to be operationally simple and economically feasible for Slovenia. As there is little information available about two-phase OMW produced in the northern Mediterranean regions, the aim was to determine its composition and evaluate its use as a soil amendment in olive groves. This study shows that the characteristics of two-phase olive-mill waste produced in northern Mediterranean regions are similar to those of other countries. In addition, the calcareous characteristics of the Mediterranean soil can reduce its phytotoxic effects and might thus represent a natural system for olive-mill waste treatment. Phenolic compounds in the two-phase olive-mill waste are rapidly decomposed, and the soil has a high buffering capacity. Furthermore, the results of the soil analysis also showed some effects on the soil properties, such as a significant increase in K₂O and soil organic carbon. The combined application of two-phase olive-mill waste and mineral fertilizer to olive groves on eutric cambisols has positive effects on the physical, chemical and biochemical properties of the soil.

Olives affected by active and damaging infestation (olive fruit fly Bactrocera oleae (Rossi)) were assayed for their chemical composition. Biophenols were determined by HPLC, sterols, triterpenic dialcohols, and fatty acids by gas chromatography analysis. The acquired data were statistically analyzed. Oils produced from “Istrska belica” fruit affected by active infestation compared to the oils made from fruit affected by damaging infestation showed higher amounts of total oleuropein biofenols (377.3 versus (vs.) 106.6 mg/kg), total biophenols (755 vs. 377 mg/kg), lignans (85.3 vs. 32.9 mg/kg), the dialdehydic form of decarboxymethyl oleuropein aglycone (DMO-Agl-dA) (148.3 vs. 49.0 mg/kg), its oxidized form (DMO-Agl-dA)ox (35.2 vs. 8.5 mg/kg), the dialdehydic form of oleuropein aglycone (O-Agl-dA) (61.1 vs. 8.0 mg/kg), the dialdehydic form of ligstroside aglycone (L-Agl-dA) (63.5 vs. 28.0 mg/kg), the aldehydic form of oleuropein aglycone (O-Agl-A) (40.6 vs. 8.4 mg/kg), and lower amounts of tyrosol (Tyr) (6.0 vs. 13. 9 mg/kg) and the aldehydic form of ligstroside aglycone (L-Agl-A) (13.8 vs. 40.3 mg/kg). Higher values of stigmasterol (2.99%) and lower values of campesterol (2.25%) were determined in oils affected by damaging infestation; an increase in triterpenic dialcohols was also observed (3.04% for damaging and 1.62% for active infestation). Oils affected by damaging infestation, compared to active infestation, showed lower amounts of oleic acid (73.89 vs. 75.15%) and higher amounts of myristic (0.013 vs. 0.011%), linoleic (7.27 vs. 6.48%), and linolenic (0.74 vs. 0.61%) acids.

In recent years, early olive fruit drop has been observed in the northern Mediterranean regions, causing significant economic losses, although the exact cause remains unknown. Recent studies have identified several possible causes; however, our understanding of how olive trees respond to these environmental stresses remains limited. This study includes an analysis of selected meteorological and flowering data for Olea europaea L. “Istrska belica” to evaluate the use of a chilling and forcing model for a better understanding of flowering time dynamics under a changing climate. The flowering process is influenced by high diurnal temperature ranges (DTRs) during the pre-flowering period, resulting in earlier flowering. Despite annual fluctuations due to various climatic factors, an increase in DTRs has been observed in recent decades, although the mechanisms by which olive trees respond to high DTRs remain unclear. The chilling requirements are still well met in the region (1500 ± 250 chilling units), although their total has declined over the years. According to the Chilling Hours Model, chilling units—referred to as chilling hours—represent the number of hours with temperatures between 0 and 7.2 °C, accumulated throughout the winter season. Growing degree hours (GDHs) are strongly correlated with the onset of flowering. These results suggest that global warming is already affecting the synchrony between olive tree phenology and environmental conditions in the northern Mediterranean and may be one of the reason for the green drop.

Due to increased occurrence and intensity of agricultural droughts in humid Mediterranean regions, monitored irrigation is becoming an increasingly inevitable element of agricultural practice. To determine the impact of different irrigation regimes on olive tree (Olea europaea L.) growth and crop yield, and of the olive oil production and biophenol content, a 3-year study was conducted in an olive grove located in a relatively humid region of southwestern Slovenia. The mean olive production from trees under full irrigation (replacement of 100% crop evapotranspiration) was significantly higher than those that were only rain fed or were under deficit irrigation (replacement of 33 and 66% crop evapotranspiration). There were no significant differences in total biophenol contents of the olive oil across these irrigation treatments. These irrigation effects can be explained according to the levels of precipitation throughout the growing season. Despite the positive effects of rainfall on these parameters, the mean olive oil yield of the rain-fed olives was about 30% lower than that for the deficit irrigation treatments.

This study evaluated the authenticity of olive oil in canned tuna products from the Slovenian market using both official methods, including fatty acid (FA) profiling, determination of the equivalent carbon number difference (ΔECN42), and sterol analysis, and an advanced method: stable carbon isotope analysis (δ¹³C) of FAs obtained through compound-specific isotope analysis (CSIA). Results from both methods confirmed that all 10 samples were authentic, as per the limits set by EU Regulation 2022/2104 and supported by the scientific literature. Method performance was further evaluated by adulterating the olive oil from the canned tuna with 5–20% vegetable oil (VO) or hazelnut oil (HO). While FA analysis struggled to differentiate adulterants with similar FA profiles, CSIA of FAs significantly improved detection. However, distinguishing between VO and HO blended samples remained challenging. PLS-DA analysis further supported the potential of using δ¹³C values of FA for food authentication. Storage of adulterated samples also influenced FA composition, leading to significant changes in MUFA/PUFA ratios and δ¹³C values, which became less negative, likely due to oxidative degradation. In summary, the combination of official and advanced methods, supported by chemometric analysis, offers a robust approach to ensuring the authenticity of olive oil in canned tuna.