Chu Hoang

Dr. Chu Hoang

orcid

Research Focus & Metrics

Academic Career Length

14Years (2013-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
22 May 2014 in IEEE Photonics Technology Letters
Verified
Journal Article
Closed access
CHChu Hoang
Chu Hoang
KHKazuhiro Hane
Kazuhiro Hane
A wide-range wavelength-tunable silicon microring resonator is proposed using a microelectromechanical actuator. The microring consists of two U-shaped silicon freestanding waveguides and two directional couplers. The circumference of the microring is varied by the actuator. The wavelength dependence of the couplers is compensated by adjusting the coupling length while varying the circumference. The initial circumference of the microring is 19.1 μm and the free spectral range is 21 nm. The resonant wavelength of the microring is varied by 27 nm at the applied voltage of 25 V with negligible power consumption.

1 February 2017 in Micromachines
Verified
Journal Article
Open access
PDF file
MNMinh Ngoc Nguyen
Minh Ngoc Nguyen
NHNhat Sinh Ha
Nhat Sinh Ha
LNLong Quang Nguyen
Long Quang Nguyen
CHChu Hoang
Chu Hoang
HVHung Ngoc Vu
Hung Ngoc Vu
This paper reports on the design and fabrication of a z-axis tuning fork gyroscope which has a freestanding architecture. In order to improve the performance of the tuning fork gyroscope by eliminating the influence of the squeeze-film air damping, the driving and sensing parts of the gyroscope were designed to oscillate in-plane. Furthermore, by removing the substrate underneath the device, the slide-film air damping in the gap between the proof masses and the substrate was eliminated. The proposed architecture was analyzed by the finite element method using ANSYS software. The simulated frequencies of the driving and sensing modes were 9.788 and 9.761 kHz, respectively. The gyroscope was fabricated using bulk micromachining technology. The quality factor and sensitivity of the gyroscope operating in atmospheric conditions were measured to be 111.2 and 11.56 mV/°/s, respectively.

19 October 2020 in Nanotechnology
Verified
Journal Article
Closed access
PDF file
PTPham Van Tuan
Pham Van Tuan
LHLe Trung Hieu
Le Trung Hieu
CHChu Hoang
Chu Hoang
HTHoang Ba Tuong
Hoang Ba Tuong
VTVu Thi Tan
Vu Thi Tan
TKTran Ngoc Khiem
Tran Ngoc Khiem
Water pollution abatement is a problem in today’s society that requires urgent attention. Moreover, photocatalysts are an effective method to treat environmental pollution, and SnO 2 /reduced graphene oxide composite photocatalysts have been extensively studied in recent years. The synthesis parameters for these photocatalysts significantly affect their morphologies, structures, and properties. In this study, we investigated the effects of annealing temperatures on the properties of SnO 2 /reduced graphene oxide nanocomposites, which were hydrothermally fabricated at 180 °C for 24 h and annealed at 200 °C–800 °C. The structural characteristics of the fabricated nanocomposites were studied via x-ray diffraction, field emission scanning electron microscopy, and Raman scattering analyses. The observed results indicated that increasing the annealing temperature from 200 °C to 800 °C increased the average SnO 2 nanoparticle size from 4.60 nm to 9.27 nm; in addition, the Raman scattering peaks of the SnO 2 increased, and those of the reduced graphene oxide significantly decreased as the annealing temperature was increased. Furthermore, the specific surface area of the samples decreased due to the increase in calcination temperature. The amount of reduced graphene oxide content in all the samples was measured using thermo-gravimetric analysis. The optical properties of the samples were studied using ltraviolet–visible absorption spectra, and their photocatalytic activity was evaluated by decomposing methylene blue under visible light using the samples as catalysts. In particular, the photocatalytic properties of nanocomposites decreased significantly with increasing annealing temperature. Among the samples, the photocatalytic activity of that annealed at 200 °C is most satisfactory as it has the smallest particle size and the largest specific surface area. The results of our research could facilitate the production of efficient catalysts with suitable properties.

27 February 2019 in Photonics
Verified
Journal Article
Open access
PDF file
NHNguyen Thanh Huong
Nguyen Thanh Huong
NCNGUYEN VAN CHINH
NGUYEN VAN CHINH
CHChu Hoang
Chu Hoang
In this paper, we propose and investigate the modal characteristics of wedge surface plasmon polariton (SPP) waveguides for guiding surface plasmon waves. The wedge SPP waveguides are composed of a silver layer deposited onto the surface of a wedge-shaped silicon dielectric waveguide. The wedge-shaped silicon dielectric waveguides are explored from the anisotropic wet etching property of single crystal silicon. The wedge SPP waveguides are embedded in a dielectric medium to form the metal–dielectric interface for guiding the surface plasmon waves. The propagation characteristics of the wedge SPP waveguides at the optical telecommunication wavelength of 1.55 μm are evaluated by a numerical simulation. The influence of the physical parameters such as the dimensions of the wedge SPP waveguide and the refractive index of the dielectric medium on the propagation of the surface plasmon wave is investigated. In addition, by comparing the propagation characteristics, we derive the wedge SPP waveguide with the optimal performance.

15 January 2022 in Materials Science in Semiconductor Processing
Verified
Journal Article
Closed access
NMNguyen Van Minh
Nguyen Van Minh
DHDang Van Hieu
Dang Van Hieu
PTPham Van Tuan
Pham Van Tuan
NDNguyen Duc Dung
Nguyen Duc Dung
CHChu Hoang
Chu Hoang

11 May 2020 in Applied Physics Express
Verified
Journal Article
Closed access
VPVinh N. T. Pham
Vinh N. T. Pham
CHChu Hoang
Chu Hoang
HHHo Thanh Huy
Ho Thanh Huy
LDLe Tri Dat
Le Tri Dat
NVNguyen Duy Vy
Nguyen Duy Vy
Amir  Farokh ParamAmir Farokh Param
Amir Farokh Param