As the application of nanotechnology increases continuously, the need for controlled size nanoparticles also increases. Therefore, in this work, we discussed the growth mechanism of carbon nanoparticles generated in Ar+CH4 multi-hollow discharge plasmas. Using the plasmas, we succeeded in continuous generation of hydrogenated amorphous carbon nanoparticles with controlled size (25–220 nm) by the gas flow. Among the nanoparticle growth processes in plasmas, we confirmed the deposition of carbon-related radicals was the dominant process for the method. The size of nanoparticles was proportional to the gas residence time in holes of the discharge electrode. The radical deposition developed the nucleated nanoparticles during their transport in discharges, and the time of flight in discharges controlled the size of nanoparticles.
Using an Ar + CH4 multi-hollow discharge plasma chemical vapor deposition (MHDPCVD) method, carbon nanoparticles (CNPs) are synthesized in a size range between 10 nm and 100 nm at gas pressures from 2 Torr to 5 Torr. The size of the nanoparticles increases from 45.42 nm(3) at 2 Torr to 67.85 nm(3) at 5 Torr. The size dispersion also increases. Conversely, the optical emission intensities and generation of carbon related radicals decrease with increasing pressure. The Raman measurements indicate that these CNPs are composed of polymer structures containing relatively high clustered and distorted sp2 sites. (C) 2019 The Japan Society of Plasma Science and Nuclear Fusion Research
1 October 2020 in Japanese Journal of Applied Physics
Carbon nanoparticles (CNPs) incorporated diamond-like carbon (DLC) films have been fabricated by a combination of rf sputtering and plasma chemical vapor deposition. Spherical CNPs with a mean size of 21.2 nm are sandwiched between DLC layers with a mass density of 1.7 g cm −3 . The film stress is decreased to 119 MPa, by depositing the CNPs over the base DLC layer at a surface coverage of 10.7%. This reduction is approximately half of that without CNPs. Raman spectroscopy indicates the insertion of CNPs barely alters the bonding structure of the upper DLC layer.
Double layers composed of Sn and Mg, each 0.8 μm thick, were fabricated on a hot-dip galvanized steel (8.4 μm) sheet using DC magnetron sputtering and post-annealing processes. With an increase in temperature, the surface morphologies were agglomerated with each other. Additionally, Sn/Mg mixture sites, including an intermetallic compound of Mg2Sn, were formed at 190 °C and locally clustered at 220 °C. In the salt-spray test, the corrosion resistance of the Sn/Mg film prepared at 190 °C was 960 h, which is longer than that at non-heat for 528 h or 220 °C for 480 h. In the polarization test, the Sn/Mg film formed at 190 °C displayed a lower corrosion current density of 1.07 μA/cm2 and potential of 1.62 V/SSCE than those at non-heat or 220 °C.