Impurity concentrations of oxygen, carbon, nitrogen, iron, and other heavy metals should be well controlled in silicon crystals to maintain the crystal quality for application in electronic and solar cell devices. Contamination by impurities occurs during the melting of raw materials and during the crystal growth process. Quantitative analysis of impurity transfer using numerical and experimental analysis is important to control impurity concentrations. This paper reviews the analysis of the impurity transport phenomena in crystal growth furnaces of Czochralski and directional solidification methods by a model of global analysis and an experiment during the crystal growth of silicon.
This paper reports the relationship between oxygen concentration and dislocation multiplication in silicon crystals during directional solidification using numerical analysis. Based on the Alexander–Haasen–Sumino model, this analysis involved oxygen diffusion from the bulk to dislocation cores during crystal growth and annealing processes in a furnace. The results showed that the dislocation density mainly increased during cooling process, rather than crystal growth, when the effect of oxygen diffusion to dislocation cores was ignored. On the contrary, the dislocation density increased during both crystal growth and cooling processes when the effect of interstitial oxygen diffusion was considered. At a dislocation density larger than 1.0 × 105 cm−2, the interstitial oxygen concentration in bulk decreased due to the diffusion process, if interstitial oxygen atoms were between dislocations, whereas the concentration at dislocation cores increases.
For bulk doping, boron and phosphorus are usually used as p-type and n-type dopants, respectively. The distribution of these dopant concentrations in a silicon crystal along the vertical direction is governed by the segregation phenomena. As the segregation coefficient of phosphorus is small, phosphorus concentration distribution in a silicon crystal becomes inhomogeneous; inhomogeneous phosphorus concentration distribution affects the distribution of resistivity in the crystal. Therefore, it is important to control the phosphorus concentration distribution in a silicon crystal and make it uniform. In this study, by numerical analysis, we investigated the effect of the evaporation flux at the melt surface on phosphorus concentration distribution during the directional solidification process. To obtain a homogeneous phosphorus concentration distribution in the silicon crystal, we had to control the phosphorous evaporation flux at the melt surface and maintain approximately the same phosphorus concentration in the melt during the entire solidification process even though the growth rate was always changing.
A numerical simulation has been carried out to study the asymmetric heat transfer, fluid flow, and three-phase line to explain the phenomenon of the spillage of the melt in floating zone (FZ) silicon growth. A three-dimensional high-frequency electromagnetic (EM) field is coupled with the heat transfer in the melt and crystal calculation domains. The current density along the three-phase line is investigated to demonstrate the inhomogeneous heating along the three-phase line. The asymmetric heating is found to affect the flow pattern and temperature distribution of the melt. The three-dimensional solid–liquid interface results show that, below the current supplies, the interface is deflected due to strong heating below the current supplies. The calculated asymmetric three-phase line shows a similar trend as the experimentally observed results. The results indicate that the re-melting and spillage phenomenon could occur below the current supplies.