Wet troposphere path delay (WPD) is a crucial error source for wide-swath altimeters with high-resolution observations. This study generated a simulated wide-swath through the nadir microwave radiometer (MWR) track and evaluated four wide-swath wet tropospheric correction (WTC) methods based on multisource data from 2017 with strict spacetime windows. The numerical weather model (NWM) method can provide a basic correction for the wide-swath altimeter. The MWR method, based on the extension of nadir one-beam MWR, could not provide a reliable correction. The residual error increased rapidly after deviating from the nadir profile. The overall root-mean-square error (RMSE) of the combination method was approximately 0.58 cm and had high uniformity within the swath. Even at the far end of the swath, the correction was better than that on the NWM and MWR methods. The objective analysis (OA) method using linear spatiotemporal OA had the best result among the four correction methods. The overall RMSE was only 0.49 cm, which was 34% lower than the NWM method. High consistency was maintained at each cross-track position of the swath. The last two wide-swath WTC methods provided in this study had high performance. For the wide-swath altimeter, the combination method is a scheme worthy of consideration, as it can provide WTC results conveniently, quickly, and accurately. Although the operation of the OA method is complex and depends on multisource observation data, it promises to be a high-quality scheme for the wide-swath altimeter WTC when a more accurate WTC value is required.
22 August 2024 in International Journal of Remote Sensing
The baseline error is a primary error source of the wide-swath altimeter, directly related to the cross-track distance, and can lead to serious height errors at the swath’s outer edge. Cross-calibration using discrepancies with reference data can effectively estimate and correct the baseline error. However, building a reference surface that accurately describes the sea surface at the observation time is necessary to use this cross-correction method. The dynamic ocean environments where the sea surface structure changes over time are challenging. This paper proposes a method for constructing reference topography data (RTD) based on multi-source data products to correct the baseline error of the wide-swath altimeter. The effectiveness of the proposed method is evaluated using HYCOM ocean model data to assess the timeliness of the baseline error correction. The results demonstrate that using RTD at the observation time of the wide-swath altimeter can significantly correct the baseline error. The RMSE of the corrected sea surface height (SSH) in different regions is typically between 1~2 cm, except in some regions with strong currents where the RMSE is approximately 3~4 cm. However, the time interval between the RTD and the observation time of the wide-swath altimeter can affect the accuracy of the baseline error correction. The timeliness of this correction is influenced by the variability of SSH in different regions. In regions with relatively slow SSH changes near the equator, the effective time based on HYRTD and MORTD can basically reach more than 7 days. In regions where the SSH changes more rapidly, the correction result may no longer be reliable in only 1~3 days.
1 January 2026 in IEEE Journal of Selected Topics in Applied Earth Observations and Remote Sensing