Snow represents a fundamental water resource for mountain and lowland areas. Changes in the frequency and magnitude of snow droughts can significantly impact societies and ecosystems that rely on snowmelt to satisfy their water demands. Here we documented and quantified the snow drought that affected the Italian Alps during the early 2020s. We used 15 long-term snow-depth series (period 1930–2023, elevation range: 864–2200 m a.s.l.) to simulate the snow water equivalent (SWE), in conjunction with climatic reanalysis data and river discharge observations. We found that the March SWE anomaly in 2022 reached the lowest value in the last century, due to an unprecedented combination of drier- and warmer-than-normal conditions in the period December 2021–March 2022. This event contributed to causing critical hydrological conditions in the Po and Adige rivers which, during summer 2022, experienced the worst hydrological drought ever recorded. Despite its unprecedented magnitude, the snow drought in 2022 is part of a recent pattern of increased intensity and frequency of snow-drought events since the 1990s, due to the combined increasing occurrence of warmer- and drier-than-normal climatic conditions during the snow season. Remarkably, three out of the five most severe snow-drought events occurred in the last five years, with exceptional snow-drought conditions even occurring in the last two consecutive winters, 2022 and 2023. The snow-drought conditions that occurred in the early 2020s in the Italian Alps warn of the pressing need for the implementation of impact mitigation measures to adapt to the fast changing snow and climatic conditions.
This paper concerns a stepwise modelling procedure for groundwater flow simulation in a folded and faulted, multilayer carbonate aquifer, which constitutes a source of good quality water for human consumption in the Apennine Range in Central Italy. A perennial river acts as the main natural drain for groundwater while sustaining valuable water-related ecosystems. The spatial distribution of recharge was estimated using the Thornthwaite–Mather method on 60 years of climate data. The system was conceptualized as three main aquifers separated by two locally discontinuous aquitards. Three numerical models were implemented by gradually adding complexity to the model grid: single layer (2D), three layers (quasi-3D) and five layers (fully 3D), using an equivalent porous medium approach, in order to find the best solution with a parsimonious model setting. To overcome dry-cell problems in the fully 3D model, the Newton–Raphson formulation for MODFLOW-2005 was invoked. The calibration results show that a fully 3D model was required to match the observed distribution of aquifer outflow to the river baseflow. The numerical model demonstrated the major impact of folded and faulted geological structures on controlling the flow dynamics in terms of flow direction, water heads and the spatial distribution of the outflows to the river and springs.
Management of water supply systems under shortage conditions due to drought requires computational tools able to relate the past precipitation regime over different time scales to future water resources availability. This work proposes a modelling framework to address the occurrence of shortage for water supply systems whose resource is constituted by natural or artificial reservoirs. The proposed methodology aims at identifying “management triggers” for possible mitigation measures. Emphasis is given on the use of standardized indices to promote information sharing. The implemented tool is structured into five modules: “hydrological” module; “scenarios” module; “reservoir” module; a module for the evaluation of “indices of shortage”; and a “support to early-warning” module. The whole procedure has been applied to three Italian reservoirs. For each water body, a case specific shortage early-warning system, based on standardized precipitation indices has been identified, allowing the implementation of efficient local mitigation measures.
This paper concerns about a stepwise modelling procedure for groundwater flow simulation in a complex carbonate, folded and faulted, multilayer aquifer, in the Apennine chain in Central Ita-ly, which constitutes a source of good quality water for human consumption. A perennial river acts as the main natural drain for groundwater while sustaining valuable water related ecosys-tems. The spatial distribution of recharge was estimated using the Thornthwaite-Mather method on 60 years of climate data. The system was conceptualized as three main aquifers separated by two locally discontinuous aquitards. Three numerical models were implemented by gradually adding complexity to the model grid: single layer (2D), three layers (Quasi-3D), and five layers (Fully-3D), using an equivalent porous medium approach, in order to find the best solution with a parsimonious model setting. To overcome dry-cell problems in the Fully-3D model, the New-ton-Raphson formulation for MODFLOW-2005 was invoked. Calibration results show that a Fully-3D model was required to match the observed distribution of aquifer outflow to the river baseflow. The numerical model demonstrated the major impact of folded and faulted geological structures on controlling the flow dynamics in terms of flow direction, water heads and spatial distribution of the outflows to the river and springs.
GIS technology has been used for many years in environmental risk analysis due to its capability to focus on the management and analysis of geographic and alphanumeric data to support spatial decision-making (Vairavamoorthy et al, 2007). Especially in emergency management, a DSS (Decision Support System) constitutes an important task to provide quick responses, though not completely exhaustive, to immediately handle a critical scenario and limit the possible damage. In the framework of a collaboration between the Water Research Institute and the National Civil Protection Department, a customized tool called CREGIS (ContaminazioneRisorseEvento-GIS) has been developed in order to facilitate the emergency management of accidental contamination of aquifers and support decision making (Preziosi et al, 2013). The tool is aimed at both national and local authorities in order to improve response capability for a better emergency management. Originally, the tool has been developed programming Python in an ArcGIS environment; but due to the great development and dissemination of open source software, our aim is to replicate the same structure programming Python in a GIS open source environment (QGIS). The review of the tool's code is still in progress. The goal is to make the tool (now named CREGIS-Q) free and accessible to a greater number of people and stakeholders.
The present work provides an insight into the emergency preparedness and coping capacity of Italian water utilities, based on the results of two ongoing research projects. Specific attention is given to the role that Water Safety Plans (WSPs) may have in this framework. The results of an online survey completed with a wide sample of Italian water utilities have been integrated with the evidence from targeted in-depth interviews, with the aim of: (i) characterizing the state of implementation of WSPs in Italy; (ii) identifying the main challenges, barriers and opportunities; (iii) describing the key issues related to the interactions among different institutions. A critical summary of the main evidence was structured in the form of a SWOT analysis.