Ability of machines to fly was based on the complex mechanical units until the end of last century. Development of high-quality and affordable sensors brings the innovation to this sector. The complex mechanical parts can be replaced by electronics. The construction of multi propeller platform includes DC motors, power electronics, microcomputer, sensors and simple frame. It doesn't require complex mechanical parts. Electronics of the multikopter contains commonly available components. Management and control is compared with conventional helicopter eased considerably. Navigation, in cooperation with the built-in microprocessor can apply some automatic features like auto start, landing and return from any position to start, etc.
This paper introduces a machine vision-based system promising low-cost solution for detecting a fatigue crack propagation caused by alternating mechanical stresses. The fatigue crack in technical components usually starts on surfaces at stress concentration points. The presented system was designed to substitute a strain gauge sensor-based measurement using an industrial camera in cooperation with branding software. This paper presents implementation of a machine vision system and algorithm outputs taking on fatigue crack propagation samples.
The article describes a unique method of processing scanned point cloud on a moving object with variable speed. Point clouds represent a set of trucks loaded by a scanning gate made up of four 2D laser scanners. Three scanners record the surface of the truck from three sides, the fourth scanner records the longitudinal change of the profile of one of a truck's side. From this profile, the method evaluates the motion movement function by which all other point clouds are recalculated. The result is a modified point clouds representing the surface of the standing set. The article also provides a way of point segmentation that separates the points representing the timber load from the truck.
This paper exposes the Control technology embedded in a propeller propulsion for Unmanned Aerial Vehicle (UAV). The system relies on systems combining low-cost sensors, embedded controller and control algorithms based on aerodynamics models. Presented results are for standard propeller assignment and advanced assignment using the variable pitch propeller and its algorithms.
This contribution describes procedures and results obtained at the Department of Control Systems and Instrumentation of the VřB-Technical University of Ostrava during research and mathematical modelling of variable pitch systems behavior. The wiring scheme and control strategy of the electronic variable pitch drive mounted on new testing stand are presented. Ability of machines to fly had been based on the complex mechanical units until the end of last century. Development of high-quality and affordable sensors brings the innovation to this sector. The presented stand was created for testing of the new optimized control algorithms for UAV devices (multicopter). The complex mechanical parts can be replaced by electronics. The construction of EVP testing stand includes BLDC motor, power electronics (ESC), microcontroller, sensors and simple frame. It doesn't require complex mechanical parts. Management and control is compared with conventional helicopter eased considerably.
The transfer of graphics to a product’s surface is a widely known technology. Printing, engraving, and etching are used every day in production processes with countless types of materials. This paper deals with quality control for laser engraving on surfaces with variable dimensions via optical sensors. The engraving process, apart from colour changes, can induce volume and moisture changes, which lead to dimension changes in some materials. Natural materials and biomaterials are among the ones most affected. Combined with the porous and inhomogeneous structure of such a material, it can be difficult to measure the quality of graphic transfer, especially for shaded products. The quality control of laser-engraved photographs on thin layers of wood veneer was selected as a suitable problem to solve. A complex method for the quality measurement of the specified production was designed and tested. We used an affine transformation to determine the system behaviour and to determine the transfer function of material changes during the production process. Moreover, there is a possibility to compensate the image deformation of the engraved product.