Laser engraving of photographs on wood surfaces is a challenging task. To optimize the outcome and production quality it is necessary to control every aspect of the laser engraving process. Most of the production machines and technologies overall are mainly focused on laser power control. However, with other systems and deeper knowledge of the wood characteristics it is possible to achieve even better quality. This paper deals with enlarging the number of achievable shades of burned wood and its optimization. A calibration system was developed to control colour shades of engraved wood with a combination of laser power and optic focus. With this approach it is possible to widen achievable palette of engraved shades by continuous control of chemical processes of laser and wood interaction. The production is divided into wood burning and wood carbonization by variation of laser beam focus.
11 July 2017 in Journal of Physics: Conference Series
The advantage of journal hydrodynamic bearings is high radial load capacity and operation at high speeds. The disadvantage is the excitation of vibrations, called an oil whirl, after crossing a certain threshold of the rotational speed. The mentioned vibrations can be suppressed using the system of the active vibration control with piezoactuators which move the bearing bushing. The motion of the bearing bushing is controlled by a feedback controller, which responds to the change in position of the bearing journal which is sensed by a pair of capacitive sensors. Two stacked linear piezoactuators are used to actuate the position of the bearing journal. This new bearing enables not only to damp vibrations but also serves to maintain the desired bearing journal position with an accuracy of micrometers. The paper will focus on the effect of active vibration control on the performance characteristics of the journal bearing.
Testing the quality of manufactured products based on their sound expression is becoming popular nowadays. To maintain low production costs, the testing is processed at the end of the assembly line. Such measurements are affected considerably by the factory noise even though they are performed in anechoic chambers. Before designing the quality control algorithm based on a convolutional neural network, we do not know the influence of the factory noise on the success rate of the algorithm that can potentially be obtained. Therefore, this contribution addresses this problem. The experiments were undertaken on a synthetic dataset of heat, ventilation, and air-conditioning devices. The results show that classification accuracy of the decision-making algorithm declines more rapidly at a high level of environmental noise.
This paper introduces a machine vision-based system promising low-cost solution for detecting a fatigue crack propagation caused by alternating mechanical stresses. The fatigue crack in technical components usually starts on surfaces at stress concentration points. The presented system was designed to substitute a strain gauge sensor-based measurement using an industrial camera in cooperation with branding software. This paper presents implementation of a machine vision system and algorithm outputs taking on fatigue crack propagation samples.
This paper deals with design and implementation of control system for superheated steam temperature control of high pressure part in the small biomass power plant. It describes the steam superheating technology, the actual state and the way how to realize the improvement in this control. The designed control algorithm represents standard cascade control with two PI controllers with some additions like feed forward control applied on measured disturbance, compensation of level change in steam production and compensation of valve nonlinearity. The important fact, in terms of control algorithms implementation, is verification of control system properties during the change of process dynamics (load level step) and response to disturbances. The Simulink model was used for the simulation experiment. Some significant simulation results from simulation tests and from the real time tests are presented. The improved control structure was implemented to the PLC and tested on the plant. Additionally a comfortable and user-friendly interface for controller's parameterization and compensation of valve nonlinearity was created. The response of the new control system and the original control system response are compared.
This paper presents the current results of cooperation focused on automatic billet straightening machine development. First, an experimental study of three-point bending realized on small specimens is presented to explain the basic ideas of the straightening. Then, the main regimes of straightening and the algorithm itself are described together. Subsequent finite element simulations of operational experiments show the applicability of the developed theory. The significance of material parameters estimation is depicted in this work. At least four parameters have to be properly determined for a new material in the straightening process.