A heterojunction tunneling field effect transistor with an L-shaped gate (HJ-LTFET), which is very applicable to operate at low voltage, is proposed and studied by TCAD tools in this paper. InGaAs/GaAsSb heterojunction is applied in HJ-LTFET to enhance the ON-state current (I_ON). Owing to the quasi-broken gap energy band alignment of InGaAs/GaAsSb heterojunction, height and thickness of tunneling barrier are greatly reduced. However, the OFF-state leakage current (I_OFF) also increases significantly due to the reduced barrier height and thickness and results in an obvious source-to-drain tunneling (SDT). In order to solve this problem, an HfO2 barrier layer is inserted between source and drain. Result shows that the insertion layer can greatly suppress the horizontal tunneling leakage appears at the source and drain interface. Other optimization studies such as work function modulation, doping concentration optimization, scaling capability, and analog/RF performance analysis are carried out, too. Finally, the HJ-LTFET with a large I_ON of 213 μA/μm, a steep average SS of 8.9 mV/dec, and a suppressed I_OFF of 10⁻¹² μA/μm can be obtained. Not only that, but the fT and GBP reached the maximum values of 68.3 GHz and 7.3 GHz under the condition of Vd = 0.5 V, respectively.

To cope with the much narrower ESD design window in 28 nm CMOS technology, a novel diode-triggered silicon-controlled rectifier with an extra discharge path (EDP-DTSCR) for ESD protection is proposed in this paper. Compared with the traditional DTSCR, the proposed DTSCR has an enhanced current discharge capability that is achieved by creating a slave SCR path in parallel with the master SCR path. Moreover, the improved triggering and holding characteristic can be obtained by the proposed EDP-DTSCR. By sharing the anode emitter junction, a slave SCR path is constructed that is symmetrical to the position of the master SCR path to add an additional ESD discharge path to the EDP-DTSCR. In this way, the current discharge capability of the entire device is obviously improved. The TCAD simulation result shows that the proposed device has a remarkably lower on-resistance compared with the traditional DTSCR and the DTSCR with p-type guard ring (PGR-DTSCR). In addition, it is structurally optimized to further increase the holding voltage and reduce the trigger voltage to improve the anti-latching capability of the device, which is more conducive to the ESD protection window application of 28 nm CMOS technology.

A power clamp circuit, which has good immunity to false trigger under fast power-on conditions with a 20 ns rising edge, is proposed in this paper. The proposed circuit has a separate detection component and an on-time control component which enable it to distinguish between electrostatic discharge (ESD) events and fast power-on events. As opposed to other on-time control techniques, instead of large resistors or capacitors, which can cause a large occupation of the layout area, we use a capacitive voltage-biased p-channel MOSFET in the on-time control part of the proposed circuit. The capacitive voltage-biased p-channel MOSFET is in the saturation region after the ESD event is detected, which can serve as a large equivalent resistance (~10⁶ Ω) in the structure. The proposed power clamp circuit offers several advantages compared to the traditional circuit, such as having at least 70% area savings in the trigger circuit area (30% area savings in the whole circuit area), supporting a power supply ramp time as fast as 20 ns, dissipating the ESD energy more cleanly with little residual charge, and recovering faster from false triggers. The rail clamp circuit also offers robust performance in an industry-standard PVT (process, voltage, and temperature) space and has been verified by the simulation results. Showing good performance of human body model (HBM) endurance and high immunity to false trigger, the proposed power clamp circuit has great potential for application in ESD protection.