Dandan Ju

Dr. Dandan Ju

orcid

Research Focus & Metrics

Academic Career Length

7Years (2020-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
29 October 2020 in RSC Advances
Verified
Journal Article
Open access
PDF file
DJDandan Ju
Dandan Ju
SCSun Chengyue
Sun Chengyue
WHWang Hao
Wang Hao
WXWang Xinmin
Wang Xinmin
YWYiyong Wu
Yiyong Wu
XQXuepeng Qiu
Xuepeng Qiu
Compared with the single irradiated sample, the tensile strength and elongation at break after the combination of proton irradiation and strain increased, indicating that introducing strain during irradiation will weaken the damage of irradiation.

28 November 2022 in Polymers
Verified
Journal Article
Open access
PDF file
IKIlya Kobykhno
Ilya Kobykhno
AKAndrey Kiryanov
Andrey Kiryanov
VV. Klinkov
V. Klinkov
ACAlla Chebotareva
Alla Chebotareva
Stanislav EvlashinStanislav Evlashin
Stanislav Evlashin
Oleg TolochkoOleg Tolochko
Oleg Tolochko
In this work, we studied the influence of the geometry and degree of filling of glass dispersed particles on the optical and mechanical properties of flexible high-transmission composites, based on thermoplastic polyurethane. Glass spheres, glass flake and milling glass fiber were used as fillers. Studies of mechanical properties have shown that the introduction of any filler leads to a decrease in tensile strength and an increase in the elastic modulus of the composite material, however, with the introduction of glass flakes and milling glass fiber, a significant increase in the yield strength of the material is observed. The optical properties of composites with glass spheres decrease exponentially with an increase in the volume fraction of the filler. With an increase in the concentration of glass flakes and milling glass fiber to 10 vol.%, a sharp decrease in transmission is observed. With a further increase in concentration, the orientation of the filler along the film occurs, due to which the transmission in the visible range increases to values close to those of a pure polymer.

11 March 2024 in Polymers
Verified
Journal Article
Open access
PDF file
DJDandan Ju
Dandan Ju
WYWu You
Wu You
HWHao Wang
Hao Wang
CSChengyue Sun
Chengyue Sun
YWYiyong Wu
Yiyong Wu
CLChangjiang Li
Changjiang Li
The response and mechanism of polyimide aerogel under electron irradiations were investigated. The experimental results indicated that electron irradiation could not damage the skeleton polyimide in the aerogel due to its high stability, but could result in a discharge within. The morphology of the discharge shows some dendritic discharge patterns, and the material surrounding the discharge channels was carbonized. The numerical simulation results indicated that the incident electrons, and also large amount induced secondary electrons, would be deposited inhomogeneously within the nano-porous polyimide aerogel. This would result in forming an ultra-high electrical potential of up to about 8.5 × 1010 V/m (which is far higher than the breakdown strength (2 × 108 V/m) of bulk polyimide materials) in a local region. This may be the leading cause of the obvious discharge in the materials. Furthermore, it was found that the actual reason for the discharge is related to the residual gas within the nano-porous structure; namely, the more internal residual gas (as a shorter-time vacuum pumping in the irradiated chamber), the more serious the discharge phenomenon. Correspondingly, the phenomenon may largely consist of both residual-gas discharge and surface flashover due to ultra-high local potentials induced by unevenly deposited charges in the porous aerogel.

29 August 2022 in Polymers
Verified
Journal Article
Open access
PDF file
WYWu You
Wu You
DJDandan Ju
Dandan Ju
HWHao Wang
Hao Wang
CSChengyue Sun
Chengyue Sun
YWYiyong Wu
Yiyong Wu
Oleg TolochkoOleg Tolochko
Oleg Tolochko
The transport behaviors of proton into nanoporous materials were investigated using different Monte Carlo simulation codes such as GEANT4, Deeper and SRIM. The results indicated that porous structure could enhance the proton scattering effects due to a higher specific surface area and more boundaries. The existence of voids can deepen and widen the proton distribution in the targets due to relatively lower apparent density. Thus, the incident protons would transport deeper and form a wider Bragg peak in the end of the range, as the target materials are in a higher porosity state and/or have a larger pore size. The existence of voids also causes the local inhomogeneity of proton/energy distribution in micro/nano scales. As compared, the commonly used SRIM code can only be used to estimate roughly the incident proton range in nanoporous materials, based on a homogeneous apparent density equivalence rule. Moreover, the estimated errors of the proton range tend to increase with the porosity. The Deeper code (designed for evaluation of radiation effects of nuclear materials) can be used to simulate the transport behaviors of protons or heavy ions in a real porous material with porosity smaller than 52.3% due to its modeling difficulty, while the GEANT4 code has shown advantages in that it is suitable and has been proven to simulate proton transportation in nanoporous materials with porosity in its full range of 0~100%. The GEANT4 simulation results are proved consistent with the experimental data, implying compatibility to deal with ion transportation into homogeneously nanoporous materials.

14 March 2025 in Journal of Radiation Research and Applied Sciences
Verified
Journal Article
Open access
YWYou Wu
You Wu
CLChangjiang Li
Changjiang Li
XGXinxin Guo
Xinxin Guo
DJDandan Ju
Dandan Ju
HWHao Wang
Hao Wang
GJGuiru Jing
Guiru Jing

23 June 2021 in Chinese Physics B
Verified
Journal Article
Closed access
PDF file
YZYu Zhao
Yu Zhao
WZWenyue Zhao
Wenyue Zhao
DJDandan Ju
Dandan Ju
YYYue-Yue Yao
Yue-Yue Yao
HWHao Wang
Hao Wang
WFWei-Dong Fei
Wei-Dong Fei
Lead zirconate titanate piezoelectric ceramics have important applications in space and aerospace technology, but the effect and physical mechanism of charged particle radiation on their performance yet to be clarified. In this study, we characterized PbZr0.52Ti0.48O3 (PZT) thin films, and changes in the ferroelectric properties of the films before and after electron and proton irradiation were investigated. The natural and heat treatment recoverability of the ferroelectric properties were studied, and the damages and mechanisms of different types of radiation in PZT films were also investigated. The results show that, in addition to ionization damages, electron irradiation causes certain structural damage on the PZT film, and the large structural damage caused by proton irradiation reduces drastically the ferroelectricity of the PZT film.