Compression sportswear is specialized clothing chiefly designed for the athletes muscle fatigue reduction. Compression stockings are widely used in sportswear to support muscles and control excessive body vibrations. Compression/interface pressure between the wearer and stocking’s surface is considerable in compression sportswear efficacy. However, thermo-physiological comfort is also influential while preparing summer sportswear. The research investigates the effect of fibers type and the inlay yarns number of covering filaments on compression, air permeability, water vapor permeability, and thermal resistance of sportswear compression stockings. Three different fibers, sorbtek (channelized polyester), nylon 6, and micro Nylon (polyamide-6), have been used as main yarns. Also, three distinct levels of covering yarn number of filaments have been utilized. Data have been statistically analyzed using full factorial design of experiment and regression analysis to predict fiber type and the number of covering yarn filaments for achieving desired comfort properties without compromising compression characteristics.

The research aims the development of knitted reinforcement structures for inducing self-diagnostic properties into knitted reinforced composites for structural health monitoring. Conductive carbon fiber was used in knitted inlaid structures as inlay yarns, and l × 1 Rib knitted base fabric of polyester filament yarn was used for knitting. The reinforcement’s conductive nature induced self-diagnostic properties into composites using correlation of mechanical damages and changes in electrical resistance values. Single and double stimuli layers and inlay patterns of 3 × 1, 6 × 1 and 9 × 1 was used to check their impact on self-diagnostic properties. Mechanical testing and real-time electrical resistance monitoring proved knitted structures as a solution to induce self-diagnostic properties into composite materials. Composites having double stimuli (conductive) layers exhibited better self-diagnostic properties than single stimuli layer composites, and the self-diagnostic properties also improved as the inlay pattern of reinforcement moved from 9 × 1 to 6 × 1 and 3 × 1 inlay. Such knitted reinforced self-diagnostic composites could be practically used in structural health monitoring applications, e.g., complicated structures of large buildings infrastructures and machinery which require record of each minor happening with structures to keep smooth and successful running of the system.

Knitted sports socks remain in continuous scuff with wearers’ feet and shoes during activities. Such continuous physical contact governs severe pills on socks surface, which is unpleasant for both the wearer and the working life of socks. Hence it becomes necessary to take measures for controlling fabric deterioration, that is, anti-pilling treatments. Though pilling performance is enhanced; however, thermal comfort characteristics are compromised through the treatments. Simultaneous acquirement of both pilling and thermal characteristics is an area of interest. Fiber denier and yarn doubling techniques are among the influential factors in the solution to the problem. Specimens have been developed using four different fiber deniers, two yarn doubling conditions, and two specialty wet treatments under a full factorial experimental design. Results showed a significant variation in pilling behaviors and thermal characteristics before and after treatments in the statistical analysis, predicting the possible stages, that is, a combination of experimental factors for desired characteristics attainment.

Knitted fleece fabrics with superior comfort characteristics are chiefly focused in winter wear. Thermal characteristics are an area of interest in selecting fleece clothing. However, environmental hazards also need to be focused. Fleece clothing is worn in cold areas having higher ultraviolet rays exposures. Hence the clothing should have the capability of combating environmental challenges. The study focuses on engineering variable fleece structures with different materials. Cotton, nylon, and polypropylene fleece patterns have been knitted using fleece 1:1, 3:1, and 2:2 patterns. The designs vary by tuck and miss stitch configurations in the fleece course. Comfort characteristics were determined through air permeability, moisture management, and thermal resistance tests. Performance criteria were evaluated in terms of pilling resistance and ultraviolet protection factor (UPF) investigation. Structures and materials owing better comfort characteristics with satisfactory UPF have been predicted as safe clothing in UV affected zones, that is, fleece 3:1 possessed the optimum comfort characteristics and UPF simultaneously; however, the mechanical performance was better for 2:1 and 1:1 fleece fabric due to less amount of miss stitch floating yarns.