Fe3O4 (magnetite) nanoparticles were synthesized by chemical co-precipitation method. The structure, morphology and magnetic properties of as-prepared were characterized by X Ray Diffraction (XRD), Scanning Electron Microscope-Energy Dispersive X Ray Spectrometry (SEM-EDS), Transmission Electron Microscope (TEM) and Vibrating Sample Magnetometer (VSM). The result of XRD characterization was indicated Fe3O4 as the product. SEM and TEM image of the Fe3O4 showed nanoparticles Fe3O4 have the mean diameter 5-20 nm. The EDS spectra showed strong peaks of Fe and O. Magnetic characteristic of Fe3O4 nanoparticles was indicated super paramagnetic properties. The saturation magnetic was 89.46 emu g-1. Therefore, the nanoparticles Fe3O4 is suitable to remove dye in the water by a simple magnetic separation process. The optimum adsorption occurred at initial concentration of procion dye 100 mg L-1, pH solution 6, dosage of Fe3O4 0.8 g L-1 and contact time 30 minutes under room temperature with color removal 24.40 % and adsorption capacity was 30.503 mg g-1
22 May 2021 in Bulletin of Chemical Reaction Engineering & Catalysis
The synthesis chitosan-methylene bridge-Schiff base of 4,4-diaminodiphenyl ether-vanillin using casting method has been done. The aims of this research were modification chitosan with Schiff base of 4,4-diaminodiphenyl ether-vanillin, formaldehyde and its characterization using FTIR spectroscopy, SEM analysis, 1H-NMR and X-Ray Diffraction analysis. The first step was a synthesis of modified chitosan between chitosan and Schiff base of 4,4-diaminodiphenyl ether-vanillin. The second step was chitosan modified Schiff base of 4,4-diaminodiphenyl ether-vanillin then reacted with formaldehyde through casting method. The result showed that chitosan can be modified with Schiff base of 4,4-diaminodiphenyl ether-vanillin and formaldehyde and this modified chitosan can be linked by methylene bridge (-NH-CH2-NH-) and had azomethine group (-C=N-). The functional group of –C=N in modified chitosan before and after adding formaldehyde appeared at a constant wavenumber of 1597 cm-1. The functional group C-N in methylene bridge detected at 1388 and 1496 cm-1. The chitosan-Schiff base of 4,4-diaminodiphenyl ether-vanillin and Chitosan-methylene bridge-Schiff base of 4,4-diaminodiphenyl ether-vanillin had index crystalline (%)16.04 and 25.76, respectively. The chemical sift of signal proton azomethine group (-C=N-) in modified chitosan detected at 8.44–8.48 and 9.77 ppm. Proton from methylene bridge in modified chitosan appeared at 4.97–4.99 and 3.75 ppm. Surface morphology chitosan-methylene bridge-Schiff base of 4,4-diaminodiphenylether-vanillin had dense surfaces, mostly uniform and regular in shape.
This study describes the co-precipitation synthesis of magnetic bentonite-Fe3O4 for photocatalytic degradation of methylene blue and Congo red pigments under visible light. Bentonite-Fe3O4 composites were produced using the mass ratio of 2:1 and 1:1 for bentonite to Fe3O4, respectively. X-ray Powder Diffraction (XRD), Fourier Transform Infra-Red (FTIR), BET surface area, Vibrating-Sample Magnetometer (VSM), Scanning Electron Microscopy with Energy Dispersive Spectroscopy (SEM-EDS), and Ultraviolet–Visible Diffuse Reflectance Spectroscopy (UV DRS) were used to characterize the materials. The bentonite-Fe3O4 (1:1) composite exhibited a greater surface area in comparison to the bentonite-Fe3O4 (2:1) composite with a measured value of 106.6 m2/g. It is a superparamagnetic material with a band gap of 2.25 eV and a saturation magnetization of 69.64 emu/g. The photocatalytic degradation of dye using bentonite-Fe3O4 (1:1) with the initial dye concentration of 25 mg/L, volume of 50 mL, catalyst dose of 0.05 g/L, addition of 3 mL H2O2, and 90 minutes of visible irradiation resulted in 94.34% and 98.45% degradation efficiency of methylene blue and Congo red dyes, respectively. The study determined that the most favorable pH for the photocatalytic degradation of methylene blue was pH 11, whereas the optimal pH for Congo red was found at pH 5. For methylene blue and Congo red dyes, photocatalytic degradation followed pseudo-first-order with the constant rates of 0.0356 min-1 and 0.0348 min-1, respectively. After five cycles of use in the photocatalytic process, the catalyst's degradation efficiency fell into below 5%. This research demonstrated that catalysts could be utilized in wastewater treatment technology.
1 January 2022 in Journal of Ecological Engineering
This study successfully synthesized a core-shell-shell in the form of CoFe2O4-SiO2-TiO2 catalyst magnetic and recyclable. The catalyst for the photocatalytic degradation of methyl orange (MO) dye. Subsequently, the catalyst was subjected to XRD, FTIR, SEM-EDS, VSM, as well as UV-DRS...