Silicon-based photovoltaic technology is helpful in reducing the cost of power generation; however, it suffers from economic losses and environmental pollution caused by silicon cutting waste. Herein, a hydrothermal method accompanied by heat treatment is proposed to take full advantage of the photovoltaic silicon cutting waste and biomass excrementum bombycis to fabricate flake-like porous Si@C (FP-Si@C) composite anodes for lithium-ion batteries (LIBs). The resulting FP-Si@C composite with a meso-macroporous structure can buffer the severe volume changes and facilitate electrolyte penetration. Meanwhile, the slightly graphitic carbon with high electrical conductivity and mechanical strength tightly surrounds the Si nanoflakes, which not only contributes to the ion/electron transport but also maintains the electrode structural integrity during the repeated lithiation/delithiation process. Accordingly, the synergistic effect of the unique structure of FP-Si@C composite contributes to a high discharge specific capacity of 1322 mAh g−1 at 0.1 A g−1, superior cycle stability with a capacity retention of 70.8% after 100 cycles, and excellent rate performance with a reversible capacity of 406 mAh g−1 at 1.0 A g−1. This work provides an easy and cost-effective approach to achieving the high-value application of photovoltaic silicon cutting waste, as well as obtaining high-performance Si-based anodes for LIBs.
It is of great significance to recycle the silicon (Si) kerf slurry waste from the photovoltaic (PV) industry. Si holds great promise as the anode material for Li-ion batteries (LIBs) due to its high theoretical capacity. However, the large volume expansion of Si during the electrochemical processes always leads to electrode collapse and a rapid decline in electrochemical performance. Herein, an effective carbon coating strategy is utilized to construct a precise Si@CPPy composite using cutting-waste silicon and polypyrrole (PPy). By optimizing the mass ratio of Si and carbon, the Si@CPPy composite can exhibit a high specific capacity and superior rate capability (1436 mAh g−1 at 0.1 A g−1 and 607 mAh g−1 at 1.0 A g−1). Moreover, the Si@CPPy composite also shows better cycling stability than the pristine prescreen silicon (PS-Si), as the carbon coating can effectively alleviate the volume expansion of Si during the lithiation/delithiation process. This work showcases a high-value utilization of PV silicon scraps, which helps to reduce resource waste and develop green energy storage.
With high theoretical specific capacity, the low-cost MoO3 is known to be a promising anode for lithium-ion batteries. However, low electronic conductivity and sluggish reaction kinetics have limited its ability for lithium ion storage. To improve this, the phase engineering approach is used to fabricate orthorhombic/monoclinic MoO3 (α/h-MoO3) homojunctions. The α/h-MoO3 is found to have excessive hetero-phase interface. This not only creates more active sites in the MoO3 for Li+ storage, it regulates local coordination environment and electronic structure, thus inducing a built-in electric field for boosting electron/ion transport. In using α/h-MoO3, higher capacity (1094 mAh g−1 at 0.1 A g−1) and rate performance (406 mAh g−1 at 5.0 A g−1) are obtained than when using only the single phase h-MoO3 or α-MoO3. This work provides an option to use α/h-MoO3 hetero-phase homojunction in LIBs.