In this paper, an accurate linear model of the Mueller–Muller phase detector (MMPD)-based clock and data recovery circuit (MM-CDR) is proposed, which analyzes several critical points of the MM-CDR including the linearization of the MMPD and the gain of the voter. Using our technique, the jitter between the recovery clock and the input data can be estimated with a sub-picosecond accuracy, as demonstrated in the simulation results of a 56 Gb/s quarter-rate MM-CDR implemented in 28 nm CMOS.

This paper analyzes the performance requirements that need to be met by a clock generator applied to a low-temperature quantum computer and analyzes the negative effects on the clock generator circuit under low-temperature conditions. In order to meet the performance requirements proposed in this paper and suppress the negative effects brought about by the low temperature, a clock generator for ultra-low-temperature quantum computing is designed. This clock generator is designed by using F-CLASS Voltage Controlled Oscillator (VCO), power filter, tail resistor, differential charge pump, and other techniques. And the noise characteristics of the clock generator are analyzed by Impulse Sensitive Function (ISF) and simulation results. After simulation tests, the average power consumption of the clock generator designed in this paper is 7 mW, the phase noise is −121 dBc/Hz@1 MHz, and the jitter is 62 fs. The performance of the clock generator meets the performance requirements proposed in this paper, and the reduction in the corner frequency proves that the circuit will have better performance at low temperatures.

This paper presents a 20 GS/s four-channel time-interleaved sample-and-hold amplifier (SHA), which aims to improve the harmonic distortion performance, eliminate the common-mode voltage fall in track-to-hold transition, and solve the difficulty of timing mismatch calibration among different sampling channels. In data path, the harmonic distortion of the track-hold switch is optimized by introducing a distortion-improving resistor into the switched emitter follower. The common-mode voltage fall is eliminated by an inserted delay-regulating resistor. Additionally, broadband data buffers are utilized to further guarantee a wide bandwidth. In clock path, an interpolator-based phase regulator in analog domain is implemented to calibrate the timing mismatch, hence avoiding the large area cost and complicated algorithm in the digital domain. Fabricated in a 0.18 μm SiGe BiCMOS process, the experimental results show that the SHA achieves a bandwidth of 16 GHz and a total harmonic distortion of −39.6 to approximately −51.8 dB with a −3 dBm input. By applying the proposed sampling phase regulator, the timing mismatch can be optimized to satisfy the requirement of 6-bit resolution at a 4 × 5 GS/s sampling rate. The proposed SHA shows prominent performance on both bandwidth and linearity, which makes it suitable for ultra-high-speed communication networks.

To reduce the high bit error rate of serial transceivers under strong channel attenuation, a low-power 112 Gb/s SerDes transmitter was designed using a duo-binary PAM4 modulation technology. By adopting duo-binary PAM4 modulation technology, the problem of the low bandwidth utilization of a high-speed PAM4 (pulse amplitude modulation 4) signal was improved. The problem of high jitter caused by charge sharing and the limited bandwidth of a 4:1 high-speed MUX was improved by using precharging auxiliary transistors. The system power consumption of the transmitter was reduced by using a 7-bit weighted voltage-driven digital-to-analog converter (DAC). The transmitter was designed with a 28 nm CMOS process and powered by a voltage of 0.9 V. The simulation results showed that when the channel attenuation was 20.9 dB, the transmitter could work at 112 Gb/s, the power consumption was 2.02 pJ/bit, and the linearity was 96.7%.