Power generation and wastewater treatment are two great challenges for sustainable development. Microbial fuel cells (MFCs) are a sustainable alternative that can generate bioelectricity in the bioremediation process of wastewater. For this reason, the objective of this research was to generate bioelectricity through double-chamber microbial-combustion cell systems from wastewater from the Covicorti Wastewater Treatment Plant (PTARC) in the anodic chamber and electrogenic bacteria such as Stenotrophomonas maltophilia, Acinetobacter bereziniae, and Achromobacteria xylosoxidans in the cathode chamber, respectively. Measurements of the voltage, current, power density, current density, and optical density of the bacteria and biochemical oxygen demand (BOD) were made. In addition, a metagenomic analysis of the wastewater sample was performed. It was shown that the MFC with A. xylosoxidans generated the highest voltage peak (1.01 ± 0.06 V) on day 24, while the MFC with S. maltophilia generated the highest current value (0.71 ± 0.02 mA). The pH levels were slightly alkaline, and the maximum anodic conductivity value was presented by the MFC with A. cerevisiae, with a peak value of 81 ± 2 mS/cm on day 24. On the other hand, a maximum power density and current density of 195,493 ± 4717 mW/m² and 4987 A/cm², respectively, were obtained in the MFC with A. xylosoxidans. Finally, the metagenomic analysis identified the predominant phyla of Proteobacteria present in wastewater samples capable of generating electrical energy as Bacillota, Pseudomonadota, Bacteroidota, Actinomyketone, and Campylobacterota.

The biosorption of arsenic (As) with macroalgae has aroused much interest as a clean and low-cost technology. To evaluate arsenic biosorption by Chondracanthus chamissoi and Cladophora sp., approximately 5 kg of algae was collected from Huanchaco’s beach and Sausacocha lake (Huamachuco), La Libertad. As biosorption was carried out in four column systems, with 2 g of algae pellets each, circulating As solutions of 0.25 and 1.25 ppm, respectively, at 300 mL/min cm². As concentration was determined at 3 and 6 h of treatment by flame atomic absorption spectrophotometry. Data were analyzed using Student’s t-test with 95% confidence. At 6 h, Chondracanthus chamissoi presented an As biosorption of 95.76% in a 0.25 ppm mg/L solution and 85.33% in a 1.25 mg/L solution. Cladophora sp., at 6 h, presented an As biosorption of 95.76% in a 0.25 mg/L solution and 42.03% in a 1.25 mg/L solution. It was concluded that Chondracanthus chamissoi achieves higher percentages of biosorption than Cladophora sp. in solutions of 1.25 mg/L As (p < 0.05), and that there is no significant difference between the biosorption percentages of Chondracanthus chamissoi and Cladophora sp. in a 0.25 mg/L solution of As at 6 h of treatment (p > 0.05).

Pollution generated by the misuse of large amounts of fruit and vegetable waste has become a major environmental and social problem for developing countries due to the absence of specialized collection centers for this type of waste. This research aims to generate electricity in an eco-friendly way using red dragon fruit (pitahaya) waste as the fuel in single-chamber microbial fuel cells on a laboratory scale using zinc and copper electrodes. It was possible to generate voltage and current peaks of 0.46 ± 0.03 V and 2.86 ± 0.07 mA, respectively, with an optimum operating pH of 4.22 ± 0.09 and an electrical conductivity of 175.86 ± 4.72 mS/cm at 8 °Brix until the tenth day of monitoring. An internal resistance of 75.58 ± 5.89 Ω was also calculated with a maximum power density of 304.33 ± 16.51 mW/cm² at a current density of 5.06 A/cm², while the FTIR spectra showed a decrease in the initial compounds and endings, especially at the 3331 cm⁻¹ peaks of the O–H bonds. Finally, the yeast-like fungus Geotrichum candidum was molecularly identified (99.59%). This research will provide great opportunities for the generation of renewable energy using biomass as fuel through electronic devices with great potential to generate electricity.

The growing global energy demand drives the need to develop new clean energy technologies. In this context, microbial fuel cells (MFC) are one of the emerging technologies with great potential for eco-friendly energy generation; however, the correct choice of electrode material is a significant limitation in the optimal configuration of MFCs. Therefore, this research evaluated the efficiency of activated carbon (AC) anode electrodes for bioenergy production in MFC using synthetic wastewater as a substrate. Peak values of voltage (1120 ± 0.050 mV), current (4.64 ± 0.040 mA), power density (208.14 ± 17.15 mW/cm²), and current density (5.03 A/cm²) were generated, and the R_int obtained was 214.52 ± 5.22 Ω. The substrate was operated at pH values from 5.31 to 7.66, maximum ORP values (858 mV) were reached, and turbidity was reduced to 25.11 NTU. The SEM-EDS (scanning electron microscopy–energy-dispersive X-ray spectroscopy) analyses allowed us to observe the morphology and composition of the AC electrodes, revealing a predominance of O, C, Si, Al, Fe, K, and Ca. It is concluded that the AC electrodes have the potential to produce bioenergy at a laboratory by means of MFC.

Potential use of organic waste and microalgae generates bioelectricity and thereby reduces harmful effects on the environment. These residues are used due to their high content of electron-generating microorganisms. However, so far, they have not been used simultaneously. Therefore, this research uses mango waste and microalgae Spirulina sp. in double-chamber microbial fuel cells to generate bioelectricity. The cells were made at a laboratory scale using zinc and copper electrodes, achieving a maximum current and voltage of 7.5948 ± 0.3109 mA and 0.84546 ± 0.314 V, with maximum electrical conductivity of the substrate being 157.712 ± 4.56 mS/cm and an optimum operating pH being 5.016 ± 0.086. The cells showed a low internal resistance of approximately 205.056 ± 25 Ω, and a maximum power density of 657.958 ± 21.114 mW/cm2 at a current density of 4.484 A/cm2. This research provides an excellent opportunity for mango farmers and exporting and importing companies because they can use their own waste to reduce their electricity costs when this prototype is brought to a large scale.

Research on the use of microbial biosensors for monitoring wastewater contaminants is a topic that covers few publications compared to their applicability in other fields, such as biomedical research. For this reason, a systematic analysis of the topic was carried out, for which research-type articles were reviewed during the period 2012 to September 2022. For this, different search platforms were used, including PubMed, ScienceDirect, Springer Link, and Scopus, and through the use of search equations a relevant bibliography was located. After that, the research articles were selected based on exclusion criteria. As a result, it was found that, of the 126 articles, only 16 articles were strictly related to the topic, since there was a duplication of articles among the different databases. It was possible to demonstrate the usefulness of microorganisms as components of biosensors to monitor BOD, heavy metals, and inorganic contaminants in wastewater that also had a high sensitivity. Additionally, recombinant DNA techniques were shown to improve the performance of this type of biosensor and can finally be coupled to other emerging technologies, such as microbial fuel cells (MFCs). In conclusion, it was established that microbial biosensors have high acceptability and monitoring characteristics that make them a useful tool to detect low concentrations of pollutants in wastewater that can also provide results in real-time, thus generating forms of ecological safety and social responsibility in companies where wastewater is generated.