Maria J. Balart

Dr. Maria J. Balart


Research Focus & Metrics

Academic Career Length

6Years (2021-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 December 2021 in Metallurgical and Materials Transactions A
Verified
Journal Article
Open access
PDF file
MBMaria J. Balart
Maria J. Balart
XHXinjiang Hao
Xinjiang Hao
CDClaire Davis
Claire Davis
Following observations of microcracking in two, out of three, Additive manufactured (AM) 316L steel samples, an investigation was undertaken to ascertain the root cause. Welding diagrams, taking into account composition and process parameters, could not generally account for the experimental observations of non-cracked versus cracked AM 316L samples. EBSD phase maps in all three AM samples exhibited a fully austenitic microstructure not only in the bulk sample but also near-surface. Analysis of microcracked regions in the AM samples showed the presence of local enrichment of Ni, Cu and P. Automated SEM/EDS analysis on feedstock powder samples prepared for cross-section examination revealed a fine, foreign particulate contaminant, expected to arise from NiCrCuP alloy cross-contamination during atomization, to be completely embedded in a 316L powder particle. This type of contamination would not have been revealed on examination of powder mounted onto a SEM stub, a common approach to assess powder quality. Based on this analysis, it is recommended to consider including automated SEM/EDS analysis on powder cross-sections in any standardization protocol for quality control of powders, to increase the chances of detection and identification of fine cross-contaminants. It is also recommended that atomization of NiCrCuP alloy should no longer precede atomization of 316L alloy.

30 September 2022 in Metals
Verified
Journal Article
Open access
PDF file
MBMaria J. Balart
Maria J. Balart
FGFeng Gao
Feng Gao
JPJayesh Patel
Jayesh Patel
FMFabio Miani
Fabio Miani
The effect of dilute solute additions on growth restriction in Cu-, Al-, Mg- and Ti-based binary and ternary alloys was assessed by means of the heuristic growth restriction parameter (β) modelling framework. The CALPHAD (calculation of phase diagrams) methodology was used to calculate β values from the m and k values, at first approximation, as well as from the liquid-to-solid fraction to obtain true β values. Grain size values from the literature were plotted against the corresponding true β values, showing a negative or inverse correlation between the two.