Integration of chemical vapor deposited polycrystalline diamond offers promising thermal performance for GaN-based high power radio frequency amplifiers. One limiting factor is the thermal barrier at the GaN to diamond interface, often referred to as the effective thermal boundary resistance (TBReff). Using a combination of transient thermoreflectance measurement, finite element modeling and microstructural analysis, the TBReff of GaN-on-diamond wafers is shown to be dominated by the SiNx interlayer for diamond growth seeding, with additional impacts from the diamond nucleation surface. By decreasing the SiNx layer thickness and minimizing the diamond nucleation region, TBReff can be significantly reduced, and a TBReff as low as 12 m2K/GW is demonstrated. This enables a major improvement in GaN-on-diamond transistor thermal resistance with respect to GaN-on-SiC wafers. A further reduction in TBReff towards the diffuse mismatch limit is also predicted, demonstrating the full potential of using diamond as the heat spreading substrate.
21 September 2017 in ACS Applied Materials & Interfaces
Polycrystalline diamond (PCD) was grown onto high-k dielectric passivated AlGaN/GaN-on-Si high electron mobility transistor (HEMT) structures, with film thicknesses ranging from 155 to 1000 nm. Transient thermoreflectance results were combined with device thermal simulations to investigate the heat spreading benefit of the diamond layer. The observed thermal conductivity (κDia) of PCD films is one-to-two orders of magnitude lower than that of bulk PCD and exhibits a strong layer thickness dependence, which is attributed to the grain size evolution. The films exhibit a weak temperature dependence of κDia in the measured 25–225 °C range. Device simulation using the experimental κDia and thermal boundary resistance values predicts at best a 15% reduction in peak temperature when the source-drain opening of a passivated AlGaN/GaN-on-Si HEMT is overgrown with PCD.
We present high-performance shear horizontal surface acoustic wave (SH-SAW) and longitudinal leaky SAW (LL-SAW) devices using lithium tantalate (LiTaO $_{3})$ thin films on silicon carbide (SiC) substrate. The 4-in LiTaO $_{3}$ -on-SiC (LTOSiC) hetero-substrate was prepared by an ion-slicing process. Instead of the Si-based piezo-on-insulator substrates, generally embedded with functional dielectric layers (e.g., SiO $_{2})$ , LTOSiC with a simple structure has achieved exciting results on device frequency, quality factor ( $Q)$ , temperature coefficient of frequency (TCF), and thermal transport properties. The demonstrated resonators show the scalable resonances of 1.19–4.91 GHz, in which the gigahertz SH-SAW resonator exhibits an ultrahigh Bode- $Q$ of 8100 and an excellent TCF of $-$ 4.3 ppm/K, while the LL-SAW resonator presents a high Bode- $Q$ of 1000 and an improved TCF of $-$ 25.4 ppm/K at 5.0 GHz. Besides, the demonstrated filters show the center frequencies ( $f_c)$ of 2.74–4.26 GHz, the insertion loss (IL) below 1.26 dB, and an out-of-band (OoB) rejection of 10–45 dB. The SH-SAW-based filter shows a $f_c$ of 3.36 GHz, an IL of 0.78 dB, and a 3-dB bandwidth of 180 MHz, while the LL-SAW-based filter shows a $f_c$ of 3.85 GHz and an IL of 0.85 dB. Overall, LTOSiC may serve as an advanced material platform of acoustic devices for 5G-frequency range 1 (5G-FR1) bands.
Low thermal resistance GaN-on-diamond wafers offer enhanced thermal management with respect to GaN-on-SiC devices. The GaN/diamond interfacial thermal resistance can contribute significantly to the total device thermal resistance and must therefore be minimized to gain the maximum benefit from GaN-on-diamond. A contactless thermoreflectance measurement technique has been developed, which can be used after wafer growth and before device fabrication, enabling rapid feedback about the influence of growth parameters on interfacial thermal resistance. A measured 2× reduction in the GaN/diamond interfacial resistance is achieved by reducing the dielectric thickness between the GaN and diamond from 90 to 50 nm, enabling a potential 25% increase in transistor power dissipation for GaN-on-diamond.