One of the most challenging problems for people around the world is the lack of clean water. In the past few decades, the massive discharge of emerging organic pollutants (EOPs) into natural water bodies has exacerbated this crisis. Considerable research efforts have been devoted to removing these EOPs due to their biotoxicity at low concentrations. Heterogeneous photocatalysis via coupling clay minerals with nanostructured semiconductors has proven to be an economical, efficient, and environmentally friendly technology for the elimination of EOPs in drinking water and watershed water. Natural zeolite minerals (especially clinoptilolites) are regarded as appropriate supports for semiconductor-based photocatalysts due to their characteristics of having a low cost, environmental friendliness, easy availability, co-catalysis, etc. This review summarizes the latest research on clinoptilolites used as supports to prepare binary and ternary metal oxide or sulfide semiconductor-based hybrid photocatalysts. Various preparation methods of the composite photocatalysts and their degradation efficiencies for the target contaminants are introduced. It is found that the good catalytic activity of the composite photocatalyst could be attributed to the synergistic effect of combining the clinoptilolite adsorbent with the semiconductor catalyst in the heterogeneous system, which could endow the composites with an excellent adsorption capacity and produce more e⁻/h⁺ pairs under suitable light irradiation. Finally, we highlight the serious threat of EOPs to the ecological environment and propose the current challenges and limitations, before putting the zeolite mineral composite photocatalysts into practice. The present work would provide a theoretical basis and scientific support for the application of zeolite-based photocatalysts for degrading EOPs.

The present work attempts to utilize iron tailings as the main raw materials for preparation of functional ceramics as a means of resource utilization. A new type of endothermic functional ceramics, which can be used in the field of solar energy, was prepared via semi-dry pressing followed by pressureless sintering. The results show that the functional ceramics made of 68 wt% iron tailings, 26 wt% iron ore, 3 wt% alumina, 1 wt% potash feldspar and 2 wt% kaolin, sintered at 1185 °C exhibited the best overall performance. Visual observation reveals that there were no cracks on the surface of the samples even after 20 cycles of intense thermal shock. Other attributes could be summarized as follows: Infrared emissivity in mid-infrared region: 0.85; thermal conductivity at 500 °C: 2.066 W/(m·K); flexural strength: 119.03 MPa. XRD analysis indicates that the main crystalline phases in the samples are augite, magnetite and a small amount of hematite. An increase in the proportion of iron oxide contributed to lower melting temperature of the functional ceramics, deepen color, promote densification and increase infrared emissivity. In short, the introduction of iron tailings improves the thermal and physical properties to a certain extent.