The paper concerns the development of a new scalable virtual human body model. The model has been developed to assess safety risk during various complex crash scenarios including impacts from different directions. The novel approach described couples the basic multi-body structure with deformable segments, resulting in short calculation time. Each multi-body structure segment carries the particular surface parts that are linked to the segment with non-linear springs representing the behavior of related soft tissues.The response of particular body segments (head, thorax, pelvis, lower extremities) is validated in known impact scenarios and the response of the model is tuned to the experimental corridors obtained from literature. The tuning process involved the adjustment of both model material and numerical parameters in order to get the correct response for all the tests. Several energy level impacts from different directions are usually considered in order to generalize the model; to test its robustness and correct biofidelic performance.The model is designed modularly to be simply adopted towards the pre-defined height, age and mass. The developed model is useful for the robust design of vehicles and transportation infrastructure of various sectors of transport means.
1 February 2010 in Mathematics and Computers in Simulation
The rail industry has been significantly affected by the passive safety technology in the last few years. The tram front-end design must fulfill the new requirements for pedestrian passive safety performance in the near future. The requirements are connected with a newly prepared technical guide “Tramway front end design” prepared by Technical Agency for ropeways and Guided Transport Systems. This paper describes research connected with new tram front-end design safe for pedestrians. The brief description of collision scenario and used human-body model “Virthuman” is provided. The numerical simulations (from field of passive safety) are supported by experiments. The interesting part is the numerical model of the tram windshield experimentally validated here. The results of simulations are discussed at the end of paper.
1 December 2016 in Archive of Mechanical Engineering
The main aim of the presented research was to check mechanical response of human body model under loads that can occur during airplane accidents and compare results of analysis with some results of experimental tests described in literature. In simulations, new multi-purpose human body model, the VIRTHUMAN, was used. The whole model, as well as its particular segments, was earlier validated based on experimental data, which proved its accuracy to simulate human body dynamic response under condition typical for car crashes, but it was not validated for loads with predominant vertical component (loads acting along spinal column), typical for airplane crashes. Due to limitation of available experimental data, the authors focused on conducting calculations for the case introduced in 14 CFR: Parts 23.562 and 25.562, paragraph (b)(1), knowing as the 60° pitch test. The analysis consists in comparison of compression load measured in lumbar section of spine of the FAA HIII Dummy (experimental model) and in the Virthuman (numerical model). The performed analyses show numerical stability of the model and satisfactory agreement between experimental data and simulated Virthuman responses. In that sense, the Virthuman model, although originally developed for automotive analyses, shows also great potential to become valuable tool for applications in aviation crashworthiness and safety analyses, as well.
1 January 2020 in Applied and Computational Mechanics