The quality of excavated and unloaded rock masses on steep and high slopes in cold regions is prone to deterioration, which in turn affects the long-term stability and safety of excavated slopes. Based on a triaxial unloading-damage test of sandstone, the unloading quantity was used to analyze the evolution law of unloading damage; a freeze-thaw cycle test of the unloaded-damaged samples was carried out, and it was found that the average change in porosity and the reloading peak strength damage rate after freeze-thaw increased with the increase in the number of freeze-thaw cycles, and the porosity change characteristics were independent of the value of the confining pressure at the time of the unloading damage. An exponential decay model was used, and based on the average change in porosity after freeze-thaw, a freeze-thaw strength decay model that can take into account the effect of confining pressure was established, and its ability to predict the strength decay of unloaded-damaged rock samples after freeze-thaw was verified by experimental data. The research results provide a reference for the evaluation of freeze-thaw degradation of unloaded rock masses during slope excavation in cold regions.
Seasonal freeze–thaw environments are one of the key factors that aggravate the mechanical strength decay of excavated and unloaded rock masses on reservoir banks in cold areas. To study the time-dependent mechanical properties of an excavated and unloaded rock mass on a bank slope under freeze–thaw action, triaxial unloading tests were carried out on sandstone, freeze–thaw tests simulating freezing strength were conducted, and triaxial creep tests were implemented with graded incremental loading on unloaded specimens subjected to freeze–thaw action. The test results showed that the total deformation of the unloaded specimens is significantly increased compared with the conventional specimens, and the lateral direction is more likely to produce creep behaviour than the axial direction. The level of confining pressure determines the level of creep deformation of unloaded specimens and affects the variation law of creep rate. The creep behaviour of the unloaded specimens is aggravated by freeze–thaw action and, the longer the freezing period, the larger the creep strain share, and the creep rate increases significantly. The creep damage pattern of the unloaded specimens subjected to freeze–thaw action is mainly manifested as shear damage, and the creep process intensifies the derivation of tension-type cracks in the specimens. The higher the confining pressure of the unloaded specimen, the more obvious the plastic characteristics and the weaker the brittle characteristics during creep failure. The freeze–thaw action significantly reduces the long-term strength of the unloaded specimen, which is approximately 50~55% of the instantaneous strength. The long-term strength decays significantly with an increasing freezing period, and the research results can provide a theoretical reference for the evaluation of the long-term stability of excavated and unloaded rock masses in cold areas.
The creep associated with unloading surrounding rock during the excavation of deep tunnels seriously affects the stability of the tunnel, and a high seepage pressure will aggravate the strength attenuation and structural deterioration of the surrounding rock. Based on the background of the excavation-induced unloading of the surrounding rock of a deeply buried granite tunnel with high seepage pressure, in this paper we carry out a triaxial unloading seepage creep test that considers the effects of both excavation disturbance and seepage pressure. We also analyze the mechanism of unloading and seepage pressure leading to sample failure and construct a fractional creep damage constitutive model that considers the unloading effect. The results include the following findings, firstly, seepage pressure will affect the creep deformation of rock for a long time, and the circumferential expansion of the granite creep process is more obvious than the axial expansion. Secondly, a high seepage pressure will reduce the rock bearing capacity. Under 0, 2 and 4 MPa seepage pressures, the long-term strength of the samples are 193.7 MPa, 177.5 MPa and 162.1 MPa, respectively. Thirdly, the rock damage factor increases with increasing seepage pressure, time and deviatoric stress. Finally, the rationality of a fractional-order model that considers the effect of unloading and seepage is verified by the test data. These research results may provide some reference for the stability analysis of surrounding rock during excavation in environments under high-stress and high-seepage-pressure.