To compare the shoulder load during handcycling and wheelchair propulsion under similar conditions of external power in persons with spinal cord injury. Cross-sectional. Eight men with spinal cord injury. Kinetics and kinematics were measured during handbike and wheelchair propulsion at 25, 35, 45 and 55 W on a treadmill. Shoulder load (glenohumeral contact forces, relative muscle forces) was calculated with the Delft Shoulder and Elbow Model. At all power output levels, glenohumeral contact forces were significantly lower during handcycling compared with wheelchair propulsion (p < 0.001). At 55 W, the mean glenohumeral contact force was 345 N for hand-cycling, whereas it was 585 N for wheelchair propulsion. Also, relative muscle forces were lower during handcycling. The largest differences between handbike and wheelchair propulsion were found in the supraspinatus (4.5% vs. 20.7%), infraspinatus (3.7% vs. 16.5%) and biceps (5.0% vs. 17.7%). Due to continuous force application in hand-cycling, shoulder load was lower compared with wheelchair propulsion. Furthermore, muscles that are prone to overuse injuries were less stressed during handcycling. Therefore, handcycling may be a good alternative for outdoor mobility and may help prevent overuse injuries of the shoulder complex.
Purpose: To determine the prevalence of shoulder pain and to identify factors associated with shoulder pain in a nationwide survey of individuals living with spinal cord injury (SCI) in Switzerland. Methods: Data was collected through the 2012 community survey of the Swiss SCI Cohort Study (SwiSCI) (N = 1549; age 52.3 ± 14.8; 29% female). Sociodemographic and socioeconomic circumstances, SCI characteristics, health conditions as well as mobility independence and sporting activities were evaluated as predictor variables. Analyses were adjusted for item non-response (using multiple imputation) and unit-nonresponse (using inverse probability weighting). Results: The adjusted prevalence of shoulder pain was 35.8% (95% CI: 33.4–38.3). Multivariable regression analysis revealed higher odds of shoulder pain in females as compared to males (odds ratio: 1.89; 95% CI: 1.44–2.47), and when spasticity (1.36; 1.00–1.85) and contractures (2.47; 1.91–3.19) were apparent. Individuals with complete paraplegia (1.62; 1.13–2.32) or any tetraplegia (complete: 1.63; 1.01–2.62; incomplete: 1.82; 1.30–2.56) showed higher odds of shoulder pain compared to those with incomplete paraplegia. Conclusions: This survey revealed a high prevalence of shoulder pain. Sex, SCI severity, and specific health conditions were associated with having shoulder pain.
Daily wheelchair ambulation is seen as a risk factor for shoulder problems, which are prevalent in manual wheelchair users. To examine the long-term effect of shoulder load from daily wheelchair ambulation on shoulder problems, quantification is required in real-life settings. In this study, we describe and validate a comprehensive and unobtrusive methodology to derive clinically relevant wheelchair mobility metrics (WCMMs) from inertial measurement systems (IMUs) placed on the wheelchair frame and wheel in real-life settings. The set of WCMMs includes distance covered by the wheelchair, linear velocity of the wheelchair, number and duration of pushes, number and magnitude of turns and inclination of the wheelchair when on a slope. Data are collected from ten able-bodied participants, trained in wheelchair-related activities, who followed a 40 min course over the campus. The IMU-derived WCMMs are validated against accepted reference methods such as Smartwheel and video analysis. Intraclass correlation (ICC) is applied to test the reliability of the IMU method. IMU-derived push duration appeared to be less comparable with Smartwheel estimates, as it measures the effect of all energy applied to the wheelchair (including thorax and upper extremity movements), whereas the Smartwheel only measures forces and torques applied by the hand at the rim. All other WCMMs can be reliably estimated from real-life IMU data, with small errors and high ICCs, which opens the way to further examine real-life behavior in wheelchair ambulation with respect to shoulder loading. Moreover, WCMMs can be applied to other applications, including health tracking for individual interest or in therapy settings.