A fine-grained WC-15wt%Al0.5CoCrFeNi cemented carbide was prepared through a vacuum and gas pressure sintering. For achieving high surface integrity, diamond wheel grinding serves as the primary molding process for the machining of WC cemented carbide. To reveal the influence of grinding on the surface integrity of fine-grained WC-HEA cemented carbide, studies were conducted on grinding force, surface microstructure, surface roughness, residual stress, microhardness, and bending strength. The morphological analysis of the ground surface indicated a transition in the material removal mechanism of WC-HEA cemented carbide from ductile removal to brittle removal, with brittle removal becoming predominant as the depth of grinding increases. With the increasing depth of grinding, the grinding force increases, and the grinding force increases while the surface roughness decreases. Correspondingly, there is an improvement in both hardness and bending strength. Additionally, grinding induces high residual compressive stress on the surface, with a maximum compressive stress of 1795 MPa. The bending strength of the material is found to be dependent on the residual stress.
9 October 2025 in The International Journal of Advanced Manufacturing Technology
With the wide application of permanent magnet brushless DC motors (BLDCMs) in home appliances and electric vehicles, there is increasing demand for BLDCMs with low vibration and noise. This paper aims to study the dynamic characteristics of a type of BLDCM with a rolling rotor. Firstly, a dynamic model of a BLDCM with eighteen degrees of freedom (18 DOFs) is built, for which the electromagnetic force and the oil-film force of the sliding bearing are considered. Then, the system responses are solved by Runge–Kutta numerical method, and the effects of the rotational speed, bearing backlash and eccentric distance of the rolling rotor on the dynamic response are analyzed in detail. The time history, frequency plot, axis trajectory diagram and phase portrait are introduced to discuss the dynamic behavior of the motor system. Analysis results show that eccentric force increases obviously with increasing rotational speed or eccentric distance, which can change the dynamic response through suppressing the electromagnetic force. The effect of bearing clearance on the rotor and stator is negatively correlated. Therefore, system parameters should be determined properly to improve the running performance of the motor system. Numerical results can provide a useful guide for the design and vibration control of such motor systems.
4 September 2025 in Journal of Materials Engineering and Performance