To better understand the characteristics of coupled heat transfer in liquid rocket engines, a calculation scheme is proposed in this paper. This scheme can simulate the coupled heat transfer processes, including combustion and flow in the thrust chamber, radiation heat transfer, heat conduction in the wall, heat transfer of coolant flow in the cooling channel, and gas film cooling in the thrust chamber wall. The numerical method used in each physical area, the data transfer method between each computing module, the strategy of data transfer on the coupling interface, the calculation process, and the convergence criterion are all introduced in detail. The calculation scheme was verified by analyzing a water-cooled nozzle. Then, the coupled heat transfer calculation was carried out for a liquid rocket engine using a propellant composed of unsymmetrical dimethylhydrazine and dinitrogen tetroxide. Two working conditions were analyzed: whether the gas film cooling was performed or not. The results showed that the algorithm successfully indicated the protective effect of the gas film on the wall surface, and the calculation results were reasonable. It played a guiding role for the coupled heat transfer of the liquid rocket engine using a composite cooling method.
To advance the design of conical oblique detonation engines, this study develops a rapid and accurate method for predicting wave angles and post-wave parameters. Existing theoretical models for conical oblique detonation waves are limited by simplified heat release assumptions, restricted accuracy, or high computational costs. This work addresses these limitations by solving the Taylor–Maccoll equations integrated with chemical equilibrium calculations, incorporating variable specific heat effects induced by hypersonic inflow. The proposed method achieves enhanced accuracy under both cold and heated conditions (wave angle errors of 0.001% and 0.3%, respectively) while maintaining computational efficiency. Validation against numerical simulations and experimental data confirms the method's reliability. Analysis of detonation polar curves reveals that the stationary range of conical detonation waves is narrower and weaker than that of planar counterparts at identical geometric angles. The minimum detonation Mach number for conical configurations exhibits an inverted J-shaped distribution, with the inflow Mach number dominating stationary ranges. At fixed cone angles, the detonation wave angle decreases with rising inflow temperature or decreasing pressure and peaks near equivalence ratios slightly over 1. Furthermore, conical structures in oblique detonation engines simplify wall interaction dynamics and generate higher post-wave total pressure compared to planar configurations.
Thermochemical nonequilibrium is often associated with high-Mach-number flows. The objective of this study is to investigate the effect of thermochemical nonequilibrium on combustion characterization in a Mach 10 ethylene-fueled scramjet under near-actual flight conditions. The reactive flow is numerically studied using the Navier–Stokes equations based on thermal nonequilibrium (NEQ) and thermal equilibrium (EQ) models. Results indicate that the change in internal energy distribution affects chemical reaction rates, thereby altering the distributions of species and the heat release rate in the front section of the combustor. A quantitative comparison was conducted of combustion modes and reaction paths between EQ and NEQ. Although vibrational nonequilibrium affects the combustion mode and species distribution during the ignition stage in the front section of the combustor, the combustion field in the rear section under NEQ tends to converge with that under EQ. The final combustion efficiencies under EQ and NEQ are relatively close. Based on a comparison of the characteristic timescales, the underlying mechanism is that the high wall temperature and the high fuel temperature shorten the vibration–translation relaxation time. However, the significant hot vibrational nonequilibrium within the nozzle reduces the pressure, leading to a more than 10% decrease in specific impulse compared to the EQ case.