Camilla Cappelletti

Dr. Camilla Cappelletti

University of Modena and Reggio Emilia, Modena, Emilia-Romagna, Italy
orcid

Research Focus & Metrics

Academic Career Length

5Years (2022-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
8 May 2023 in Metals
Verified
Journal Article
Open access
PDF file
Andrea GattoAndrea Gatto
Andrea Gatto
CCCamilla Cappelletti
Camilla Cappelletti
SDSilvio Defanti
Silvio Defanti
FFFabrizio Fabbri
Fabrizio Fabbri
Additive manufacturing of metal parts in the motorsport industry is becoming a decisive technology for producing lightweight and rigid parts, with increasing applications as the costs decrease. Among the available metal alloys, AlSi10Mg is one of the most widely used. In this paper, the corrosion resistance of additively manufactured AlSi10Mg is compared with that of other traditionally manufactured aluminium alloys widespread in the automotive industry. Several potentially corrosive agents, typical of vehicle applications, were used: salty water, motor oil, suspension oil, cooling fluid and gasoline. Corrosion tests were conducted at both room temperature and 90 °C. The effects of heat and surface treatments were evaluated separately. The samples were visually inspected and weighed to evaluate the corrosion rate with the aid of SEM and EDS analysis. Additively manufactured AlSi10Mg generally showed better corrosion resistance in the stress-relieved condition as compared to the T6-treated state, with slightly better results for the polished samples. Motor oil, suspension oil, cooling fluid and gasoline did not significantly corrode the specimens, except for the T6-treated AlSi10Mg samples at 90 °C. However, the corrosion rate was always higher than traditionally manufactured aluminium alloys tested for comparison.

Verified
Journal Article
Open access
PDF file
SDSilvio Defanti
Silvio Defanti
CCCamilla Cappelletti
Camilla Cappelletti
Andrea GattoAndrea Gatto
Andrea Gatto
ETEmanuele Tognoli
Emanuele Tognoli
FFFabrizio Fabbri
Fabrizio Fabbri
The Laser Powder Bed Fusion (L-PBF) process is recognized for high-end industrial applications due to its ability to produce parts with high geometric complexity. If lightweighting is one of the main strengths of L-PBF, a weakness is still the trade-off between high mechanical properties and competitive productivity. This objective can be targeted through a fine tuning of the process parameters within the manufacturing window. The paper pursues the combined optimization of part quality and process productivity for AlSi10Mg by going beyond the commonly used approach based solely on volumetric energy density. The effects of hatch distance and scan speed on the two targets were analyzed in detail. The best results were achieved by the adoption of a high scan speed and a low hatch distance, with notably different outcomes for nearly the same energy density.