High cost, unpredictable defects and out-of-tolerance rejections in final parts are preventing the complete deployment of Laser-based Powder Bed Fusion (LPBF) on an industrial scale. Repeatability, speed and right-first-time manufacturing require synergistic design approaches. In addition, post-build finishing operations of LPBF parts are the object of increasing attention to avoid the risk of bottlenecks in the machining step. An aluminum component for automotive application was redesigned through topology optimization and Design for Additive Manufacturing. Simulation of the build process allowed to choose the orientation and the support location for potential lowest deformation and residual stresses. Design for Finishing was adopted in order to facilitate the machining operations after additive construction. The optical dimensional check proved a good correspondence with the tolerances predicted by process simulation and confirmed part acceptability. A cost and time comparison versus CNC alone attested to the convenience of LPBF unless single parts had to be produced.
Recently, hairpin windings (HWs) have been among the most studied and implemented winding topologies to enhance torque and power density of electrical machines (EMs), especially in the automotive sector. The aim of this work is threefold. First, it proposes an asymmetrical configuration for HWs, which exploits the possibility of reducing AC losses through the implementation of conductors featuring variable cross-section within the slot. Second, this asymmetrical winding is envisioned using additive manufacturing (AM), given the constraints imposed by the conventional manufacturing process of HWs. Third, a suitable aluminium (Al) alloy is selected as winding material, thus replacing copper (Cu), with the aim of achieving a more sustainable design. These three objectives are achieved through extensive analytical and numerical analyses and comparisons between conventional and asymmetrical windings, as well as among different materials. A practical demonstrator is then built to validate analyses, methodologies and concepts proposed in this paper. Finally, an experimental campaign is carried out on the asymmetrical winding demonstrator, highlighting the loss reduction and sustainability potentials of the proposed layout.
Additive manufacturing of metal parts in the motorsport industry is becoming a decisive technology for producing lightweight and rigid parts, with increasing applications as the costs decrease. Among the available metal alloys, AlSi10Mg is one of the most widely used. In this paper, the corrosion resistance of additively manufactured AlSi10Mg is compared with that of other traditionally manufactured aluminium alloys widespread in the automotive industry. Several potentially corrosive agents, typical of vehicle applications, were used: salty water, motor oil, suspension oil, cooling fluid and gasoline. Corrosion tests were conducted at both room temperature and 90 °C. The effects of heat and surface treatments were evaluated separately. The samples were visually inspected and weighed to evaluate the corrosion rate with the aid of SEM and EDS analysis. Additively manufactured AlSi10Mg generally showed better corrosion resistance in the stress-relieved condition as compared to the T6-treated state, with slightly better results for the polished samples. Motor oil, suspension oil, cooling fluid and gasoline did not significantly corrode the specimens, except for the T6-treated AlSi10Mg samples at 90 °C. However, the corrosion rate was always higher than traditionally manufactured aluminium alloys tested for comparison.