This paper presents a study based on new fireproof design guidelines for dwellings against the impact of wildfires. The main objective is to present the results from the surveys of the large wildfires of 2017 in Portugal, identifying vulnerabilities in dwellings that may result in spot ignitions when exposed to wildfires. Utilizing the information gathered from these surveys, it is possible to recommend fire resistance and reaction class requirements using European indoor fire standards and adapting them to suit wildfire conditions. The study focuses on classical dwellings predominantly located in high-risk fire zones within the wildland–urban interface. These assessments have the potential to generate new fireproof construction recommendations employing traditional materials commonly found in the European construction industry.

This work presents research concerning the numerical assessment of two previously measured temperatures due to firebrand accumulation on surfaces, which was determined in former thermal experimental campaigns. A 3D numerical model using thermal transient non-linear analysis is used to validate the thermal outputs of these two previous experimental campaigns, and therefore, corroborating the previous temperature vs. time curves created with a prescribed flux in the firebrand accumulation area. The firebrand thermal heat transfer to the plane surface is simulated using convection and radiation film conditions, in which a 3D non-linear, time-dependent finite element simulation is used. Then, the previous proposed standard firebrand accumulation curve, ISO 834, and external fire curve are numerically compared with the results from previous firebrand accumulation curves in a wood corner wall. Finally, the merit assessment of the proposed standard firebrand accumulation curve shows a visible improvement, which has low values and is in accordance with the experimental results in the temperature field distribution of firebrand accumulation onto a contact surface. It is fair to argue that it constitutes a point to search for an efficient design for structures at elevated temperatures due to firebrand accumulation.

This work presents a state-of-the-art review of existing fireproof construction guidelines for dwellings against wildfires. The most important wildfire-proof construction guidelines and codes for dwellings are presented, and these are later associated with existing fire engineering chapters associated with building codes. It was concluded that the variability in this subject is very high, and the approach to classifying the thermal effects in construction still lags behind scientific consensus. Moreover, the constructive requirements depend severally on the country’s building code when assessing the fireproof requirements for wildfire. Moreover, the thermal actions of wildfires in dwellings are presented and compared with classical ISO-834 standard fire curves, in which the maximum equivalent fire exposure time can range from 2 to 4 h depending on the country’s code. The key contributions of this work consist of (i) thoroughly disseminating codes and guidelines to promote scientific discussion in order to advance the wildfire fireproof standards dedicated to WUI; (ii) emphasizing the void in current codes in order to promote conversation between future researchers.

This paper presents research concerning simulating the thermal firebrand effect due to its accumulation in exterior construction wall elements by developing a 3D finite element model (FEM) via ABAQUS (2022) software to analyze the exterior walls commonly applied to the exterior of dwellings in southern Europe and South America. A non-linear thermal transient analysis is undertaken, in which the results are directly compared with a previous experimental campaign, in which firebrands are deposited on localized surfaces of construction wall specimens, and the temperature is measured in the several layers of the construction elements. The walls are composite elements, made of different layer combinations of masonry brick and wood, varying the type of thermal insulation in the internal core from cork to classical rigid rockwool and polystyrene foam (XPS). It can be summarized from the results that the FEM effectively simulates the thermal response of brick, normal wood (NW), and cross-laminated timber (CLT) walls when insulated with materials like cork or rockwool coated with mortar against firebrand accumulation. However, the lack of accounting for uncontrolled combustion leads to inconsistent results. Additionally, for walls using XPS as the insulation material, the model requires further refinement to accurately simulate the melting phenomenon and its thermal impact.