The study presented three-dimensional (3D) analysis of water's upward flowing through the vertical pipe under turbulent characteristic considerations. Both numerical constructed and improved the model of 3D for cylindrical coordinates of governing equations for incompressible turbulent flow with the Reynolds Average Navier-Stokes (RANS) model using the improved constants of the (k–ε) type. The present model is then compared with a previous study to give the feasibility of the present single-phase turbulent flow parameters. The pipe length is tested to measure how much it affected the turbulent parameters though one of the expected factors is the turbulent time scale. On the other hand, the model is numerically examined to determine the velocity profile, shear rate, and surface deformation of the water domain. While the pressure distribution, turbulent kinetic energy, and turbulent dissipation rate, these parameters are classified as the mechanic's system factors. The simulation is done with wide software used to simulate industrial is COMSOL 5.4 Multiphysics software. The results obtained increased the velocity of three inlet water velocities used ranging from (0.087, 0.105, and 0.123 m/sec) of upward flow. High fluctuation in the water flow moves along the entire pipe length and it can notice the sensitivity to any change in water properties or mechanical properties. The liquid upward flow in turbulent conditions is suffered from many characteristics such them related to liquid properties and others related to the mechanics of the application through the systems. The interaction between the fluid film (fluid boarded the pipe inner diameter) has been observed by the shear rate and liquid surface deformation
A heat transfer modeled for predicting the wall temperature of aeration tank in a biological wastewater treatment subsystem of Hamden station is presented. The method to treatment employed depending upon the pollutants in wastewater and extent to which it is desired to eliminate them in order to congregate required standards of water quality. Several heat gain and loss mechanisms concerned to develop of the model of temperature computer includes heat gains through conduction and radiation. While the heat losses referred to convection and radiation. It classified radiation heat transfer and biological reaction as a gained heat, while classifying the rate of evaporation, aerator, and wind velocity as lost heat. This study relied on a previous study, and based on the assumptions that have been identified so that a model development can be obtained to calculate the surface temperature of the wall of the aeration tank in a biological treatment system. The operational, weather and temperature data were to be registered from Iraqi weather forecast- Basra Airport. To obtain reliable results, the model was simulated using the STELLA software v.9.02, which gave accurate results in determining the parameters that affect the tank wall temperature changes. The STELLA software is Model calibration and considers as a dynamics language because of STELLA is software for graphic and dynamic simulation for the wall temperature of aeration tank. The results have shown a good accuracy and increment between the production walls temperatures with average ranged about (0.2 %) of present work. The model shows the sensitivity through set of precious five parameters like organic removal rate, ambient air temperature, wind velocity, air relative humidity, and the wall effective area of the aeration tank
17 February 2026 in Applied Mechanics and Materials
Unmanned aerial vehicles (UAVs) are considered one of the modern technologies that have recently used in many military and civilian applications. This research investigates the aerodynamic stability of the STU.1.M predator drone was studied by studying the change in the values of the lift and drag coefficients and the lift-to-drag ratio using numerical modelling, Computational Fluid Dynamics (CFD) was employed to simulate performance across range of angles of attack (0° to 14°) at various speeds (20, 40, 60, 80 m/sec) under incompressible flow conditions. The engineering model of the aircraft was generated and the numerical validity was confirmed against experimental data from referenced study. The results indicated that the change in the value of the lift and drag coefficients and the lift-to-drag ratio with respect to UAV velocity is with no significant. The results also showed that the value of the lift coefficient and the lift-to-drag ratio increased with the increase in the value of the angle of attack, The maximum L/D ratio of 8.5 was achieved at a 6° angle of attack and speed of UAV 80 m/s, pressure and velocity contours identified stagnation regions with maximum pressure points at the UAV 's nose, wing, and tail.