Membrane chromatography is a modern, high-throughput separation method that finds important applications in therapeutic protein purification. Multimodal, salt-tolerant membranes are the most recent innovation in chromatographic membrane adsorbents. Due to the complex structure of their ligands and the bimodal texture of their carriers, their adsorption properties have not been sufficiently investigated. This work deals with the equilibrium and kinetic properties of a multimodal anion-exchange chromatography membrane, Sartobind STIC. Single- and two-component adsorption experiments were carried out with bovine serum albumin (BSA) and salmon DNA as model target and impurity components. The effect of the Hofmeister series ions and ionic strength on the BSA/DNA adsorption was investigated in micromembrane flow experiments. A significant difference was observed between the effects of monovalent and polyvalent ions when strong kosmotropic salts with polyvalent anions acted as strong displacers of BSA. On the contrary, DNA binding was rather high at elevated ionic strength, independent of the salt type. Two-component micromembrane experiments confirmed very high selectivity of DNA binding at a rather low sodium sulfate feed content and at pH 8. The strength of binding was examined in more than a dozen different desorption experiments. While BSA was desorbed relatively easily using high salt concentrations independent of buffer type and pH, while DNA was desorbed only in a very limited measure under any conditions. Separation experiments in a laboratory membrane module were carried out for the feed containing 1 g/L of BSA, 0.3 g/L of DNA, and 0.15 M of sodium sulfate. The negative flow-through mode was found to be more advantageous than the bind-elute mode, as BSA was obtained with 99% purity and a 97% yield. Membrane reuse was investigated in three adsorption-desorption-regeneration cycles.
The growing demand for therapeutic monoclonal antibodies (mAbs) has heightened the need for efficient and scalable purification strategies. A major challenge in downstream processing is the removal of antibody aggregates, which can compromise drug safety, efficacy, and regulatory compliance. This review explores the use of multimodal chromatography for aggregate separation, providing an in-depth analysis of commercially available resins and emerging adsorbent prototypes. It also examines the mechanisms of aggregate formation during bioprocessing. A comparative evaluation of conventional single-mode chromatography techniques—affinity, ion exchange, and hydrophobic interaction—is presented alongside multimodal chromatography, which integrates ion-exchange, hydrophobic, and other non-covalent interactions for enhanced aggregate clearance and process flexibility. The review primarily assesses commercial multimodal resins in terms of aggregate removal efficiency, binding capacity, and scalability. Additionally, advancements in prototype resins and multimodal membranes are discussed. Finally, the advantages, limitations, and future directions of multimodal chromatography in mAb aggregate removal are outlined. As purification demands continue to evolve, multimodal chromatography is poised to play an increasingly critical role in achieving the high purity standards required for therapeutic antibodies.
The lack of calcium and magnesium in drinking water affects people’s health, especially cardiovascular and oncologic diseases, and causes corrosion problems. The aim of this paper is to present the methodology of the design, scale-up, and construction of a fluidized bed reactor (FBR) system for drinking water recarbonization with biogenic elements in real conditions. Half-calcined dolomite (HCD) in combination with CO2 was identified as a suitable source of Mg2+ and Ca2+. The experimental results confirmed that an FBR reactor with a water tank is an efficient system for Mg and Ca2+ ion concentrate production. The main process parameters and dimensions of the equipment were determined based on the experimental data and the data obtained showed that the system can be used in real conditions to produce Mg2+ and Ca2+ ions concentrate, which is mixed with soft water in required proportions. The FBR with an internal diameter of 0.16 m and a total height of 3.7 m was designed. The proposed methodology of the recarbonization process design was used in a further system scale-up for a ten times larger capacity. Long-term experiments indicate that the HCD recarbonization process is robust and can return to the steady state even after significant changes in the process parameters for providing the desired concentration of Mg2+ and Ca2+ ions in drinking water.
Calcium and magnesium are important not only for human health but also for reducing problems related to the corrosive and aggressive effects of soft water on drinking water distribution materials. Experimental and mathematical modeling of the recarbonization process aimed at increasing the content of these biogenic elements in water was carried out using the novelty of continuous laboratory- and pilot-scale fluidized bed reactors. A methodology for scaling-up the modeled system was extended with mathematical modeling. Water remineralization was performed using half-calcined dolomite (HCD) and CO2. The influence of operating conditions, i.e., Q(CO2), freshwater inflow, and HCD dose, on quality indicators of treated drinking water (c(Ca2+), c(Mg2+), c(Ca2+ + Mg2+) and Ca/Mg) was studied. Results show that the Mg2+ concentration is more significantly affected by the amount of HCD in the system and the flow of CO2, while the effect of freshwater inflow is less significant. At constant CO2 flow, the Ca2+ content decreases and the Mg2+ content increases as the tap water inflow increases, which results in a decrease in the Ca/Mg molar ratio. However, the Ca/Mg ratio can be effectively controlled by adding an appropriate amount of HCD at certain time intervals. Overproduction of ions is easily controlled by the CO2 flow.
A gasification plant may partially replace an industrial thermal plant and hydrogen production plant by polygenerating valuable products (hydrogen, power, steam) from low-value materials. Carbon energy analysis is one way of conceptually evaluating such processes. In this paper, the integration of a heavy residue (HR) gasification plant into a mid-size oil refinery (5 million t per year crude processing rate) is conceptually assessed via the comparison of electricity, natural gas and heavy residue consumption, and CO2 emissions. The main purpose of the integration is to reduce the consumption of natural gas currently used for hydrogen production at the expense of increased HR consumption and to achieve a reduction in CO2 emissions. Two case studies with different modes of operation were compared to base case showing that annual reduction of 2280 GWh in natural gas consumption with constant heat and hydrogen production is possible, accompanied with a slight increase in electricity purchase by 28 GWh per year. HR processing in the refinery increases by over 2800 GWh per year. The refinery’s CO2 emissions increase by more than 20% (up to 350 kt per year) as a result, while, after incorporating external emissions into the balance, a decrease of more than 460 kt CO2 per year can be achieved. This confirms that the integration of gasification plants within industrial enterprises and clusters has a positive environmental and energy impact and supports the idea of converting low-value material to more valuable products in polygeneration plants. The economics of HR gasifier integration in varying operations under real refinery conditions remain to be explored.
This study investigates key factors affecting the adsorption behavior of proteins on the multimodal chromatographic adsorbent Capto MMC, aiming to enhance selective protein separation strategies. Batch equilibrium experiments were conducted using six model proteins to explore the combined effects of pH, ionic strength, and the nature of salts (kosmotropic and chaotropic) on protein–ligand interactions. Given that the Capto MMC ligand supports multiple interaction modes beyond cation exchange, particular focus was placed on acidic proteins (pI 4–5), which exhibited binding even at moderately elevated pH values—conditions ineffective for conventional cation exchangers. Hydrophobic interactions were identified as critical for stable binding of proteins like BSA and fetuin, while hydrophilic proteins such as ovalbumin showed minimal adsorption. Chromatographic column experiments were performed to evaluate elution performance under various buffer conditions, revealing that prolonged adsorption phases can reduce recovery yields for proteins with less stable tertiary structures. The findings highlight how salt type, pH, and protein hydrophobicity interplay to modulate multimodal binding mechanisms, providing practical insights for the design of tailored purification protocols.