The technology and equipment for pulsed feed of strip electrode for electric arc cladding was developed. The influence of transfer control parameters on the electrode melting process was investigated. Found that pulsing feed of the strip electrode provides optimum heat input into the base metal, stable penetration without defects of the bead formation.
22 August 2015 in Eastern-European Journal of Enterprise Technologies
A two-tape electrodes surfacing device with controlled transfer of electrode metal is proposed. The kinematical scheme and parameters of the process were investigated. It is established that the application of the developed device allows providing a more equable distribution of thermal energy across the width of the tape electrodes and a controlled dropping of liquid metal droplets.
It is proposed to use controlled mechanical transfer when the strip electrode of cylindrical products is deposited at an angle to the generatrix. The influence of the regime parameters on the stability of penetration of the base metal is determined. A mathematical model for calculating the configuration of the deposited layer is given. The analysis of advantages is carried out and conclusions are drawn about the prospects of the proposed technology for surfacing.
17 December 2019 in Eastern-European Journal of Enterprise Technologies
The paper investigates the effect of welding mode parameters on the uniformity of the deformation capacity of AISI 316 austenitic steel samples, namely, the influence of the welding current and purging gas consumption on the samples’ ability to perceive the force of cold cupping. Punch diameters of 3 and 8 mm were employed for the Erikson test to establish the dependence of the purge gas flow rate on the depth of the hole before the formation of cracks. The conducted metallographic studies confirmed an increase in the homogeneity of the dendritic structure in the weld zone due to the redistribution of heat input, as well as the absence of uneven grains and a decrease in the spread of grain sizes, which were in the range of 0.068–0.045 mm. The study resulted in determining the optimal range of technological parameters for the manufacture of flexible expansion elements to ensure their high operational properties.