A two-tape electrodes surfacing device with controlled transfer of electrode metal is proposed. The kinematical scheme and parameters of the process were investigated. It is established that the application of the developed device allows providing a more equable distribution of thermal energy across the width of the tape electrodes and a controlled dropping of liquid metal droplets.
1 September 2019 in IOP Conference Series: Materials Science and Engineering
The use of the controlling longitudinal magnetic fields (LMF) and transverse magnetic fields (TMF) at submerged arc welding and surfacing by a wire is shown. Application both LMF and TMF at the induction optimal values of the magnetic fields allows increasing the electrode wire melting productivity (melting coefficient) at arc welding and surfacing on 20…30 %. However there are no publications comparing the efficiency of the controlling LMF and TMF use at submerged arc welding and surfacing by a wire. A depth and area of parent metal penetration zone considerably decrease at the use of both ferromagnetic and non-magnetic basic and welding materials at submerged arc welding and surfacing by a wire with act of LMF and TMF. The methods of induction components calculation that generate input devices of LMF and TMF in the welding bath zone are briefly described. This comparative analysis allows establishing the areas of rational use of controlling LMF and TMF at arc welding and surfacing, taking into account the magnetic properties of basic and welding materials.
17 December 2019 in Eastern-European Journal of Enterprise Technologies
New topologies of single-phase inverter welding supplies with increased power factor are proposed. The need to increase the power factor of welding equipment is dictated by the introduction of modern standards of electromagnetic compatibility of technical equipment. One of the proposed power supplies is built on the basis of a modified forward-current converter, the other is based on a bridge converter. A distinctive feature of the presented power supplies with an increased power factor is the absence of additional inductive power components, a smaller capacity of the smoothing capacitor and a simplified scheme of limiting its charging current. The developed welding power supplies have an increased no-load voltage, which makes it possible to lightly ignite the arc during manual arc welding. Due to the increased power factor, the current consumed from the mains is 30 to 45 % lower than for widely used welding inverters without power factor correction. The presented circuit solutions of the converters allow creating welding inverter power supplies with a high-power factor, having a lower cost and better weight and size characteristics in comparison with professional welding inverters equipped with power factor correctors.
The paper investigates the effect of welding mode parameters on the uniformity of the deformation capacity of AISI 316 austenitic steel samples, namely, the influence of the welding current and purging gas consumption on the samples’ ability to perceive the force of cold cupping. Punch diameters of 3 and 8 mm were employed for the Erikson test to establish the dependence of the purge gas flow rate on the depth of the hole before the formation of cracks. The conducted metallographic studies confirmed an increase in the homogeneity of the dendritic structure in the weld zone due to the redistribution of heat input, as well as the absence of uneven grains and a decrease in the spread of grain sizes, which were in the range of 0.068–0.045 mm. The study resulted in determining the optimal range of technological parameters for the manufacture of flexible expansion elements to ensure their high operational properties.