With the deepening of drilling depth, the difficulty of drilling engineering increases gradually due to the complex geological conditions. The traditional mechanical drilling method shows the problems of high energy consumption, low efficiency, long cycle and high cost. Because of the characteristics of rock, the high abrasiveness of rock causes great wear to the bit, which becomes an important factor affecting the drilling rate. High voltage electric pulse (Abbreviated as HVEP later in this paper) drilling technology is a new technology developed in the past several decades. The technology uses plasma channel, water jet or shock wave generated by high voltage electric pulse discharge to break rock. It has the characteristics of environmental protection, directional breaking, easy control of rock breaking process and fast speed in the face of complex hard rock. In this paper, the mechanism and technology of rock breaking by high voltage electric pulse method in deep drilling are studied, and the functional test is carried out.
Mechanical equipment in the field of aerospace that is used only once is called disposable machinery. As a piece of typical disposable machinery, disposable harmonic gear exhibit stiffness failure with a large load. This manuscript distinguishes disposable harmonic gear from conventional harmonic gear in terms of the application environment and structure. Then, this paper determines the single-tooth stiffness of the disposable harmonic gear under full load by using the non-uniform beam model and the improved energy method. In addition, the multi-tooth meshing in the disposable harmonic drive is considered, and the improved energy method is modified. Besides, the normal contact force and comprehensive elastic displacement at each meshing position are calculated according to the finite element model. Additionally, curves of the single-tooth stiffness and the comprehensive meshing stiffness are obtained. The theoretical results of the modified analytical method and FEM are compared to verify the correctness of the proposed method in terms of calculating the meshing stiffness of the disposable harmonic drive. Finally, FEM is used to obtain the failure form of the disposable harmonic gear under overload.
Mechanical equipment that will not be reused is defined as disposable machinery. Disposable harmonic drives (HDs) are commonly used in the field of aerospace and are sensitive to payloads. Reasonable calculation of the gear strength is essential for structural design. A method of calculating the contact characteristics of HDs under full load by combining a surface contact model with a three-dimensional finite element model (FEM) is proposed in this work. The mathematical model was established for calculating the no-load backlash of conventional and disposable harmonic gears after assembly. Afterward, the tooth load distribution and surface contact stress were determined using the Hertz contact theory. Finally, ABAQUS software was used to establish the FEM of the disposable HD, and the results were compared with those obtained from the theoretical model. The results revealed that the disposable harmonic gear can realize short-term transmission under full load.
The rapid development of science and technology requires a large number of innovative talents to adapt to economic and social development. Critical thinking is the source of creativity. Cultivating college students' problem consciousness is an important mission of higher education. Since the traditional teaching mode weakens college students' problem consciousness, it is imperative to explore a new teaching mode. Engineering training is an important curriculum for the cultivation of engineering practical ability and quality education. It has rich teaching resources and unique advantages in cultivating students' problem consciousness. Based on the analysis of the current situation, taking turning practice, one of the typical engineering training projects, as an example, this paper discusses the main ways to cultivate college students' problem consciousness in the aspects of problems design, teaching methods and teaching reform.
19 February 2021 in U.Porto Journal of Engineering
Innovation training in engineering is an important facet of technical education in universities across China. Robotics training is a new course that has been developed using an informatization-based engineering training system at the Engineering Innovation Practice Center of the Harbin Institute of Technology. In this study, we propose a pedagogical method that combines virtual and on-site modes of teaching. Feedback obtained from students enrolled in the course showed a positive response to it. They claimed that they gained valuable knowledge from it that enabled them to carry out the relevant tasks in a better manner and more quickly. The feasibility of the proposed scheme was verified by a virtual simulation.