Hydrothermal reduction is a promising approach for graphene oxide (GO) reduction since it is environmentally friendly, simple, and cost effective. We present a detailed study of structural changes occurring in graphene oxide during the reduction process. The correlations between the interlayer spacing, chemical states, work functions, surface morphology, level of disorders, the number of layers, and processing time are elucidated. The results reveal that GO flakes remain in the early stage of the reduction process and that they are fully reduced after a 4-h hydrothermal treatment. With an increase in the reduction time, the resulting product, i.e., reduced graphene oxide, has a low oxygen content, small interlayer spacing, and crumbled and wrinkled structures. We are convinced that these properties can be tuned to a desired level for various applications.
The present work details the development of IrO2nanoparticles (nps) supported on B-doped reduced graphene oxide as an oxygen evolution reaction (OER) electrocatalyst for electrochemical water splitting.
16 February 2018 in Journal of Materials Chemistry C
Epitaxial mixed-phase bismuth ferrite (BiFeO3, BFO) thin films were successfully synthesized on (001) lanthanum aluminate (LaAlO3, LAO) substrates by a chemical solution deposition (CSD) technique. X-ray diffraction measurements confirm the co-existence of a completely relaxed rhombohedral-like (R′) phase and a strained tetragonal-like (T′) phase. Atomic resolution scanning transmission electron microscopy (STEM) measurements reveal that the T′ and R′ phases in our CSD derived BFO/LAO films are mixed homogeneously at the nanoscale. This is in stark contrast to the typical physical vapor deposition derived mixed-phase BFO thin films, which show R′ phase striations embedded in a T′ phase matrix. This phenomenon is attributed to the specific deposition-nucleation-crystallization-relaxation pathway characteristic of the CSD route. This homogenously mixed-phase still demonstrates the well-known morphotropic phase boundary effect, i.e. superior electromechanical properties compared to either the pure T′ phase or R′ phase constituents themselves. Moreover, the maximum piezoelectric coefficient measured by using nanoscale top electrodes shows surprising insensitivity to the clamping effect from the substrate, thereby offering considerable promise in thin film applications.
The mechanisms of electron irradiation damage to epoxy resin samples were evaluated using their electron diffraction patterns and electron energy–loss spectra. Their electron diffraction patterns consisted of three indistinct halo rings. The halo ring corresponding to an intermolecular distance of ∼6.4 Å degraded rapidly. Such molecular-scale collapse could have been caused by cross-linking between molecular chains. The degree of electron irradiation damage to the samples changed with the accelerating voltage. The tolerance dose limit of the epoxy resin estimated from the intensity of the halo ring was found to be improved at a higher accelerating voltage. Changes in low-loss electron energy–loss spectra indicated that the mass loss of the epoxy resin was remarkable in the early stage of electron irradiation.