Yong Yang

Prof. Yong Yang


Research Focus & Metrics

Academic Career Length

9Years (2018-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
11 November 2021 in Nanomaterials
Verified
Journal Article
Open access
PDF file
ZWZUQUAN WU
ZUQUAN WU
LLLei Liang
Lei Liang
SZShibu Zhu
Shibu Zhu
YGYifan Guo
Yifan Guo
YYYao Yao
Yao Yao
Zuowan ZhouZuowan Zhou
Zuowan Zhou
Recently, as a two-dimensional (2D) material, black phosphorous (BP) has attracted more and more attention. However, few efforts have been made to investigate the BP/polyaniline (PANI) nanocomposite for ammonia (NH3) gas sensors. In this work, the BP/PANI nanocomposite as a novel sensing material for NH3 detection, has been synthesized via in situ chemical oxidative polymerization, which is then fabricated onto the interdigitated transducer (IDTs). The electrical properties of the BP/PANI thin film are studied in a large detection range from 1 to 4000 ppm, such as conduction mechanism, response, reproducibility, and selectivity. The experimental result indicates that the BP/PANI sensor shows higher sensitivity and larger detection range than that of PANI. The BP added into PANI, that may enlarge the specific surface area, obtain the special trough structure for gas channels, and form the p–π conjugation system and p–p isotype heterojunctions, which are beneficial to increase the response of BP/PANI to NH3 sensing. Meanwhile, in order to support the discussion result, the structure and morphology of the BP/PANI are respectively measured by Fourier transform infrared spectroscopy (FTIR), ultraviolet-visible spectroscopy (UV−vis), transmission electron microscopy (TEM), and field emissions scanning electron microscopy (SEM). Moreover, the sensor shows good reproducibility, and fast response and recovery behavior, on NH3 sensing. In addition, this route may offer the advantages of an NH3 sensor, which are of simple structure, low cost, easy to assemble, and operate at room temperature.

10 December 2022 in International Journal of Control, Automation, and Systems
Verified
Journal Article
Closed access
PDF file
YYYong Yang
Yong Yang
XDXiu-cheng Dong
Xiu-cheng Dong
ZWZUQUAN WU
ZUQUAN WU
XLXiu Liu
Xiu Liu
DHDeqing Huang
Deqing Huang

26 January 2025 in Applied Sciences
Verified
Journal Article
Open access
PDF file
JMJunjie Ma
Junjie Ma
HCHongjun Chen
Hongjun Chen
XLXinglan Liu
Xinglan Liu
YYYong Yang
Yong Yang
DHDeqing Huang
Deqing Huang
The rehabilitation exoskeleton represents a typical human–robot system featuring complex nonlinear dynamics. This paper is devoted to proposing an adaptive impedance control strategy for a rehabilitation exoskelton. The patient’s motion intention is estimated online by the neural network (NN) to cope with the intervention of the patient’s subjective motor awareness in the late stage of rehabilitation training. Due to the differences in impedance parameters for training tasks in individual patients and periods, the least square method was used to learn the impedance parameters of the patient. Considering the uncertainties of the exoskeleton and the safety of rehabilitation training, an adaptive neural network impedance controller with output constraints was designed. The NN was applied to approximate the unknown dynamics and the barrier Lyapunov function was applied to prevent the system from violating the output rules. The feasibility and effectiveness of the proposed strategy were verified by simulation.

11 January 2018 in Computing in Science & Engineering
Verified
Journal Article
Closed access
YYYong Yang
Yong Yang
LMLei Ma
Lei Ma
DHDeqing Huang
Deqing Huang
YCYong Chen
Yong Chen
This paper addresses the output feedback repetitive learning control of electro-hydraulic actuator of lower limb rehabilitation exoskeleton. A repetitive learning extended state observer (RLESO) is proposed to estimate the unmeasurable system states, mismatched modeling uncertainties as well as repetitive unknowns. Based on the backstepping technique and RLESO, an output feedback repetitive controller (OFRC) is developed to improve the tracking performance. Both the convergence of the RLESO and the stability of closed-loop system are proved in a Lyapunov way. The efficiencies of the proposed RLESO and OFRC are verified via simulation. It is worthwhile to highlight that the repetitive learning scheme is integrated into both the observer and controller design parts. In such way, the remarkable performances of the output tracking via OFRC and the estimations of unmeasurable states via RLESO can be ensured.

3 January 2024 in International Journal of Control, Automation, and Systems
Verified
Journal Article
Closed access
PDF file
YWYou Wu
You Wu
XLXiu Liu
Xiu Liu
YYYong Yang
Yong Yang

18 July 2023 in Applied Sciences
Verified
Journal Article
Open access
PDF file
CSChanglin Song
Changlin Song
YYYong Yang
Yong Yang
The rehabilitation exoskeleton is an effective piece of equipment for stroke patients and the aged. However, this complex human–robot system incurs many problems, such as modeling uncertainties, unknown human–robot interaction, external disturbance, and actuator fault. This paper addresses the adaptive fault-tolerant tracking control for a lower limb rehabilitation exoskeleton joint driven by an electro-hydraulic actuator (EHA). First, the model of the exoskeleton joint is built by considering the principle of the hydraulic cylinder and the servo valve. Then, a novel disturbance-observer-based neural fault-tolerant control scheme is proposed, where the neural network and disturbance observer are incorporated to reduce the influence of the the nonlinear uncertainties and disturbance. Meanwhile, a barrier Lyapunov function is constructed to ensure the stability of the closed-loop system. Finally, comparative simulations on an exoskeleton joint validate the effect of the proposed control scheme.