This work presents the use of a transparent ‘Cross Injection Analysis’ (CIA) platform as a flow system for chemiluminescence (CL) measurements. The CL-CIA flow device incorporates introduction channels for samples and reagents, and the reaction and detection channels are in one acrylic unit. A photomultiplier tube placed above the reaction channel detects the emitted luminescence. The system was applied to the analysis of (i) Co(II) via the Co(II)-catalyzed H₂O₂-luminol reaction and (ii) paracetamol via its inhibitory effect on the catalytic activity of Fe(CN)₆³⁻ on the H₂O₂-luminol reaction. A linear calibration was obtained for Co(II) in the range of 0.002 to 0.025 mg L⁻¹ Co(II) (r² = 0.9977) for the determination of Co(II) in water samples. The linear calibration obtained for the paracetamol was 10 to 200 mg L⁻¹ (r² = 0.9906) for the determination of pharmaceutical products. The sample throughput was 60 samples h⁻¹. The precision was ≤4.2% RSD. The consumption of the samples and reagents was ca. 170 µL per analysis cycle.

This work describes a simple method for the simultaneous measurement of urinary albumin, creatinine and uric acid using a standard addition approach on a microfluidic paper-based analytical device (µPAD). Hydrophobic barrier of the µPAD was created by stamping indelible ink onto a filter paper. The µPAD was designed with a flower-liked configuration. After aliquoting urine to a central sample zone, the sample flowed to ten surrounding channels, namely “the inner channels”, where the blank (water) or standard solutions had been added. The inner channels were connected to circular reagent zones where reagents had been immobilized. Tetrabromophenolphthalein ethyl ester, alkaline picrate, and a mixed solution of ferric chloride and ferric cyanide were used as the chromogenic reagents for the colorimetric detections of albumin, creatinine, and uric acid, respectively. Each reagent zone was linked with a circular detection zone through a second channel, namely “the outer channels”. The blue-, orange- and greenish-blue colored products were observed in the detection zones for the measurement of albumin, creatinine, and uric acid, correspondingly. A digital image of the µPAD was captured with a mobile phone. The color intensities were evaluated by ImageJ^TM and were employed for the quantitative analyses. The standard addition calibrations were found to be linear (r² > 0.99) for the spiked analyte concentrations up to 100 mg L^-1 albumin, 1000 mg L^-1 creatinine, and 50 mg dL^-1 uric acid. The paper platform provided high precision (RSD < 5 %) and good analytical recovery (91.8-109.7 %). Under paired t-test, the results obtained by the developed µPAD and the validating methods were not significantly different at 95 % confidence (albumin: t_stat = -0.130, t_cri = 3.182, creatinine: t_stat = -0.133, t_cri = 3.182, and uric acid: t_stat = 1.119, t_cri = 3.182).