Kyoungjin Kim

Kyoungjin Kim


Research Focus & Metrics

Academic Career Length

19Years (2008-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
25 February 2012 in Journal of Engineering Thermophysics
Verified
Journal Article
Closed access
PDF file
KKK. H. Kim
K. H. Kim
HKH. -J. Ko
H. -J. Ko
KKKyoungjin Kim
Kyoungjin Kim
YJY. -S. Jung
Y. -S. Jung
SOS. -H. Oh
S. -H. Oh
KCK. -J. Cho
K. -J. Cho
The transient thermal behavior in the cryogenic oxidizer tank for the liquid propulsion system of the KSLV-I satellite launching space vehicle is theoretically investigated for the pressurization...

19 September 2008 in Journal of Thermal Spray Technology
Verified
Journal Article
Closed access
PDF file
KKKyoungjin Kim
Kyoungjin Kim

14 March 2022 in Journal of Engineering Thermophysics
Verified
Journal Article
Closed access
PDF file
JCJ. Choi
J. Choi
KKKyoungjin Kim
Kyoungjin Kim
A reactive bridge of nanoscale Al/Ni multilayers, or nanolaminates, is a recent advance in microscale thin-film initiator systems, potentially improving performances of explosive initiator. This numerical study introduces a three-dimensional (3D) modeling of initiator with a reactive bridge for more realistic and accurate system prediction as compared with the existing one-dimensional (1D) approximation of thin-film initiator. The model gives transient simulations for the atomic species and thermal diffusion, as well as prediction of electric potential distribution and pulsed energy deposition in the platinum bridge film. The computational results show that 3D effects are substantial such locally concentrated bridge joule heating and reduced reaction sensitivity in bimetallic multilayers by lateral heat loss. The horizontal reaction wave propagation from corners of the nanolaminates is also examined, as it effectively invalidates the 1D model of uniform bridge heating and vertical reaction advances across bimetallic multilayers. Optimization of various system design parameters is also discussed in view of achievement of best initiator performances.

30 July 2012 in Energies
Verified
Journal Article
Open access
PDF file
KKKyoung Hoon Kim
Kyoung Hoon Kim
KKKyoungjin Kim
Kyoungjin Kim
Gas turbine power can be augmented by overspray process which consists of inlet fogging and wet compression. In this study exergy analysis of the overspray process in gas turbine system is carried out with a non-equilibrium analytical modeling based on droplet evaporation and the second law of thermodynamics. This work focuses on the effects of system parameters such as pressure ratio, water injection ratio, and initial droplet diameter on exergetical performances including irreversibility and exergy efficiency of the process. The process performances are also estimated under the condition of saturated water injection ratio above which complete evaporation of injected water droplets within a compressor is not possible. The results show that the irreversibility increases but the saturated irreversibility decreases with increasing initial droplet diameter for a specified pressure ratio.

11 April 2014 in Entropy
Verified
Journal Article
Open access
PDF file
KKKyoung Hoon Kim
Kyoung Hoon Kim
KKKyoungjin Kim
Kyoungjin Kim
HKHyung Jong Ko
Hyung Jong Ko
Recently power generation systems using ammonia-water binary mixtures as a working fluid have been attracting much attention for their efficient conversion of low-grade heat sources into useful energy forms. This paper presents the First and Second Law thermodynamic analysis for a heat recovery vapor generator (HRVG) of ammonia-water mixtures when the heat source is low-temperature energy in the form of sensible heat. In the analysis, key parameters such as ammonia mass concentration and pressure of the binary mixture are studied to investigate their effects on the system performance, including the effectiveness of heat transfer, entropy generation, and exergy efficiency. The results show that the ammonia concentration and the pressure of the mixture have significant effects on the system performance of the HRVG.

8 March 2017 in Metals and Materials International
Verified
Journal Article
Closed access
PDF file
KKKyoungjin Kim
Kyoungjin Kim