Lithium iron phosphate (LiFePO4, LFP) is the most promising cathode material for use in safe electric vehicles (EVs), due to its long cycle stability, low cost, and low toxicity, but it suffers from low conductivity and ion diffusion. In this work, we present a simple method to obtain LFP/carbon (LFP/C) composites with different types of NC: cellulose nanocrystal (CNC) and cellulose nanofiber (CNF). Microwave-assisted hydrothermal synthesis was used to obtain LFP with nanocellulose inside the vessel, and the final LFP/C composite was achieved by heating the mixture under a N2 atmosphere. The resulting LFP/C indicated that the NC in the reaction medium not only acts as the reducing agent that aqueous iron solutions need (avoiding the use of other chemicals), but also as a stabiliser of the nanoparticles produced in the hydrothermal synthesis, obtaining fewer agglomerated particles compared to synthesis without NC. The sample with the best coating—and, therefore, the best electrochemical response—was the sample with 12.6% carbon derived from CNF in the composite instead of CNC, due to its homogeneous coating. The utilisation of CNF in the reaction medium could be a promising method to obtain LFP/C in a simple, rapid, and low-cost way, avoiding the waste of unnecessary chemicals.
The development of photoelectrode materials for efficient water splitting using solar energy is a crucial research topic for green hydrogen production. These materials need to be abundant, fabricated on a large scale, and at low cost. In this context, hematite is a promising material that has been widely studied. However, it is a huge challenge to achieve high-efficiency performance as a photoelectrode in water splitting. This paper reports a study of chemical vapor deposition (CVD) growth of hematite nanocrystalline thin films on fluorine-doped tin oxide as a photoanode for photoelectrochemical water splitting, with a particular focus on the effect of the precursor–substrate distance in the CVD system. A full morphological, structural, and optical characterization of hematite nanocrystalline thin films was performed, revealing that no change occurred in the structure of the films as a function of the previously mentioned distance. However, it was found that the thickness of the hematite film, which is a critical parameter in the photoelectrochemical performance, linearly depends on the precursor–substrate distance; however, the electrochemical response exhibits a nonmonotonic behavior. A maximum photocurrent value close to 2.5 mA/cm2 was obtained for a film with a thickness of around 220 nm under solar irradiation.
The fabrication of sponge-like vanadium pentoxide (V2O5) nanostructures using vertically aligned carbon nanotubes (VACNTs) as a template is presented. The VACNTs were grown on silicon substrates by chemical vapor deposition using the Fe/Al bilayer catalyst approach. The V2O5 nanostructures were obtained from the thermal oxidation of metallic vanadium deposited on the VACNTs. Different oxidation temperatures and vanadium thicknesses were used to study the influence of these parameters on the stability of the carbon template and the formation of the V2O5 nanostructures. The morphology of the samples was analyzed by scanning electron microscopy, and the structural characterization was performed by Raman, energy-dispersive X-ray, and X-ray photoelectron spectroscopies. Due to the catalytic properties of V2O5 in the decomposition of carbonaceous materials, it was possible to obtain supported sponge-like structures based on V2O5/CNT composites, in which the CNTs exhibit an increase in their graphitization. The VACNTs can be removed or preserved by modulating the thermal oxidation process and the vanadium thickness.