The modern industrial and consumer applications in accordance with the concepts of Industry 4.0 and the Internet of Things are characterized by autonomy and self-sufficiency. This has led to an increase in the interest for the so-called smart materials, capable of combining the functionalities of sensors, actuators and, in some applications, control systems. An important group of smart materials are shape-memory alloys, among which nickel–titanium (NiTi) alloys are the most known. In this article, the influence of phase transformation on the mechanical properties of thin NiTi alloy wires was investigated. During the test, the influence of the heating currents on the displacement and the force generated by the thin NiTi wires were analyzed. The temperature of the wires during heating was measured by a thermographic camera. This study proved the maximum value of the wires’ displacement was related to the value of the heating current. During the research, the dependence of the transformation dynamics on the value of the heating currents was also proved. In addition, the influence of the surface inhomogeneity of the thin NiTi alloy wires on the accuracy of the thermographic measurements was analyzed. For the experimental research described in this article, we used the NiTi alloy whose trade name is Flexinol, produced by DYNALLOY (Inc. 2801 McGaw Ave. Irvine, CA, USA).

This paper presents the results of an experimental study designed to evaluate the effect of repeated stretching cycles on the electrical resistance change in a NiTi alloy wire. In particular, tests were carried out to determine the effect of the type of loading on resistance change in the investigated wires. Wires with a diameter of 100 μm were used in the research. The experiment was carried out on a dedicated test stand designed for this purpose. During the test, the samples were subjected to 40 identical tensile cycles. The electrical resistance, sample elongation, and tensile force during successive stretching cycles were measured. The conducted research demonstrated the impact of elongation and reorientation of the structure on the resistance change in NiTi alloy thin wires. The research included a comparison of the effect of two different types of loading on the electrical resistance change in the sample. During cyclic stretching of a NiTi alloy sample with constant displacement, a decrease in electrical resistance was observed after each successive stretching cycle. Alternatively, when stretching with a constant force, the value of electrical resistance increased. In both types of loads, the greatest change in resistance value was observed at the initial cycles.

The paper presents an identification process of model parameters of a thin nickel-titanium alloy wire based on experimental research. The wire made of NiTi alloy was subjected to a tensile test to obtain the stress-strain characteristic. Parameters of the non-linear material model were identified...

As part of the research conducted, the correctness of the serial peripheral interface (SPI) communication was tested using the Raspberry Pi 4B. The purpose of the experiment was to confirm the possibility of stable data exchange between the control unit and external peripheral circuits, with...

The aim of this study was to conduct an advanced analysis of the MEMS sensor, including both experimental tests and numerical simulations, in order to determine its mechanical properties and operational dynamics in detail. It is challenging to find publications in the literature that are not based on theoretical assumptions or general manufacturer data, which do not reflect the actual microstructural characteristics of the sensor. This study uses a numerical model developed in MATLAB/Simulink, which allows the experimentally determined material characteristics to be combined with predictive dynamic modelling. The model takes into account key mechanical parameters such as stiffness, damping and response to dynamic loads, and the built-in optimisation algorithm allows the structural parameters of the MEMS accelerometer to be estimated directly from experimental data. In addition, SEM microscopic studies and EDS chemical composition analysis provided detailed information on the sensor’s microstructure, allowing its impact on mechanical properties and dynamic parameters to be assessed. The integration of advanced experimental methods with numerical modelling has resulted in a model whose response closely matches the measurement results, which is an important step towards further research on design optimisation and improving the reliability of MEMS sensors in diverse operating conditions.