Zbigniew Kęsy

Prof. Dr. Zbigniew Kęsy

orcid

Research Focus & Metrics

Academic Career Length

36Years (1991-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
19 November 2009 in Smart Materials and Structures
Verified
Journal Article
Open access
Vianney Lara-PrietoVianney Lara-Prieto
Vianney Lara-Prieto
RPRob Parkin
Rob Parkin
MJMike Jackson
Mike Jackson
VSVadim V. Silberschmidt
Vadim V. Silberschmidt
ZKZbigniew Kęsy
Zbigniew Kęsy

31 August 2011 in Smart Materials and Structures
Verified
Journal Article
Closed access
JMJózef Madeja
Józef Madeja
ZKZbigniew Kęsy
Zbigniew Kęsy
AKAndrzej Kesy
Andrzej Kesy

9 August 2017 in Smart Materials and Structures
Verified
Journal Article
Closed access
PDF file
EZE Ziabska
E Ziabska
JDJ Duchowski
J Duchowski
AOA Olszak
A Olszak
KOKarol Osowski
Karol Osowski
AKA Kesy
A Kesy
Seung-Bok ChoiSeung-Bok Choi
Seung-Bok Choi
The paper presents experimental results concerning the wear of heterogeneous electro-rheological (ER) fluids operating as working fluids in a complex clutch system consisting of a hydrodynamic clutch and a cylinder viscous clutch. The change of electric field intensity in the clutches results in change of sheer stress values in working fluids what causes the change of transmitted torque. This work shows that the most important factors affecting the wear of the ER fluid are the electric field of high intensity, the accompanying electrical breakdown, and the high temperature of the silicone oil. In addition, the water from the humid air absorbed mainly by hygroscopic particles influences a significant impact on the wear of the working fluid. Various forms of wear particles of the fluid depending on the prevailing conditions such as working mode are observed from the microscopic aspects. It is observed that the particles are flattened, rolled out or smashed into smaller fragments, partially melted, wrinkled and glued or caked. In addition, it is identified that the partial destruction of silicone oil is occurred due to the damage of the hydrocarbon chains, as evidenced by the decrease in its viscosity and the presence of the particle matter newly containing silicon.

9 November 2005 in Mechatronics
Verified
Journal Article
Closed access
ZKZbigniew Kęsy
Zbigniew Kęsy
AKA. Kesy
A. Kesy
JPJ. Płocharski
J. Płocharski
MJM. Jackson
M. Jackson
RPR. Parkin
R. Parkin

26 April 2024 in Micromachines
Verified
Journal Article
Open access
PDF file
KMKarol Musiałek
Karol Musiałek
IMIreneusz Musiałek
Ireneusz Musiałek
KOKarol Osowski
Karol Osowski
AOArtur Olszak
Artur Olszak
AMAneta Mikulska
Aneta Mikulska
Seung-Bok ChoiSeung-Bok Choi
Seung-Bok Choi
This paper presents a new type of hydraulic clutch operating by means of magnetorheological (MR) fluids and the results achieved from both theoretical analysis and experimental measurement. A hydraulic clutch system with MR working fluid and a rotating magnetic field located was designed. The clutch was based on the principle of using a rotating magnetic field created by an alternating current electromagnet to set the MR fluid in motion. To test the hydraulic clutch with a rotating magnetic field, MR fluids were produced by our laboratory, consisting of solid iron particles of various diameters mixed with a silicone oil. With MR working fluid and a rotating magnetic core was designed. The rheological properties of the MR fluids were assessed on the basis of tests carried out with a Brookfield DV2T rheometer equipped with a magnetic device for generating a magnetic field. The characteristics of the hydraulic clutch were tested on a specially built test stand. It was found that the torque transmitted by the clutch increased with the rotational speed of the magnetic field and with a lower rotational speed of the beaker in which the working fluid was placed. It was also found that the greatest torque occurred with the working fluid with the highest iron content. Based on the analysis of the structure and characteristics of the clutch in which the magnetic field is used, it has been shown that the design of the developed clutch is similar to that of an induction clutch, and its characteristics correspond to the characteristics of the eddy current clutch. Therefore, the proposed new clutch with MR fluid and rotating magnetic field can be applied to stationary power transmission systems in a manner similar to an eddy current clutch.

28 February 2011 in Measurement
Verified
Journal Article
Closed access
NIN. Islam
N. Islam
RPR.M. Parkin
R.M. Parkin
MJM.R. Jackson
M.R. Jackson
ZKZbigniew Kęsy
Zbigniew Kęsy