The article presents the research results of a D16ChATV aluminum alloy in preliminary combined loading conditions. Examination of samples was carried out by imposing additional force impulse at the monotonic tension at the stage of elastic deformation. The material modified in this way, was also subjected to fatigue testing in a low cycle fatigue loading conditions.Loading applied during the tests was oscillating sinusoidal, with the strain ratio of R=-0.2 and controlled strain amplitude ɛac=const.As a result of studies it was found, that in preliminary combined loading conditions in the test samples a processes occur related to the rapid dissipation of energy, leading to the modification of the mechanical properties of the test material.During imposing of the additional force impulse a single pulsed loading are formed the plastic zones of varying scope in the specimen made from aluminum alloy. The strength of D16ChATV aluminum alloy under a low cycle fatigue loading of the preliminary combined loading is characterized by a small increase or remains at basic level
The impact of the initial phase composition of alloys was evaluated, in particular, the content of Cu, Mn, and Mg in aluminum alloys D16ChATW, 2024-T351 and aluminum alloy T, which in its physical and mechanical characteristics is close to alloy 6013. The impact was evaluated on the effects manifested by yield sites that occur on aluminum alloys that were subject to the dynamic non-equilibrium processes (DNPs) at the expense of impact-oscillatory loading of different intensities under conditions of static tensioning, The one-time DNP, to which the investigated aluminum alloys were subjected at the pre-set levels of elastic strain followed by static tensioning, was found to cause yield sites formation. This is due to self-organization of the alloy structure, which contributes to alloy plasticization. The initial phase alloys composition impact on the yield sites, which occurs when impulse energy of a different intensity is applied to the alloys, was analyzed. The specimens from the aluminum alloys undergoing DNPs of the same level were compared. This made it possible to conclude that alloys D16ChATW and 2024-T351, which have a higher content of Cu, Mn, and Mg, have longer yield sites upon subsequent static tensioning. On the basis of the experimental results, in particular, physical studies, the authors derived a physical and mathematical model of the yield sites that appear after DNPs.
4 September 2012 in Estonian Journal of Engineering
The main regularities are found in the deformation and failure of heat-resistant steel 25Cr1Mo1V after service under static load and complex loading mode âstatic load â additional impulse loading â static loadâ, when dynamic unbalanced processes are implemented. The fractoÂgraphic investigations performed confirmed the revealed regularities in the modification of the mechanical properties of the steel 25Cr1Mo1V under the action of impulse loads of identical intensity at different levels of the preliminary static deformation.
26 July 2021 in Iranian Journal of Science and Technology, Transactions of Mechanical Engineering