We have obtained an excitation of longitudinal bulk acoustic waves in a diamond-based High overtone Bulk Acoustic Resonator (HBAR) at microwave and enhanced frequency bands as EHF up to 40 GHz. As an effective piezoelectric transducer, an aluminum-scandium nitride film is employed. The frequency response of acoustic overtones excited in the HBARs with a different aperture in the 1.0 up to 40 GHz range is measured. Some peculiarities of HBAR's frequency response concerned with the thin film piezoelectric transducer are studied. It is established that the maximal magnitude of the quality factor varies near the value of about 10 000 within all the frequency bands investigated. The approximately frequency-independent Q-factor behavior can explain in terms the Landau–Rumer approximation describing the acoustic attenuation in a diamond. An estimation of the HBAR's quality parameter as Q × f ≈ 4 × 1014 Hz at 40 GHz is obtained. In our opinion, that value exceeds all known data among the given devices. The results obtained will be helpful in the development of microwave and EHF acoustic resonators as well as highly sensitive acoustic sensors. The development of the EHF band opens up the possibility of obtaining acoustic waves of submicrometer and nanometer scales (in various media) and implementing acoustic studies of micro- and nanoobjects.
Micron- and submicron-scale 3D structure realization nowadays is possible due to the two-photon photopolymerization (TPP) direct laser writing photolithography (DLW photolithography) method. However, the achievement of lithographic features with dimensions less than 100 nm is in demand for the fabrication of micro-optical elements with high curvature values, including X-ray microlenses. Spectroscopic and photochemical study of a photoinitiator (PI) based on a methyl methacrylate derivative of 2,5-bis(4-(dimethylamino)benzylidene) cyclopentanone was performed. Enhanced intersystem crossing in the methyl methacrylate derivative results in increased radical generation for the subsequent initiation of polymerization. A comprehensive study of the new photocompositions was performed, with particular emphasis on photochemical constants, the degree of photopolymerization, and topology. The optimal parameters for the fabrication of mechanically stable structures were determined in this research. The threshold dose parameters for lithography (radiation power of 5 mW at a speed of 180 µm/s) when trying to reach saturation values with a conversion degree of (35 ± 1) % were defined, as well as parameters for sub-100 nm feature fabrication. Moreover, the 45 nm feature size for elements was reached. Fabrication of X-ray lens microstructures was also demonstrated.
1 June 2026 in Bulletin of the Lebedev Physics Institute
The geometric accuracy of refractive elements is crucial for the optimal focusing performance of compound refractive X-ray lenses. Achieving precise contro