Mahmut TANDOĞAN

Dr. Mahmut TANDOĞAN

Department of Mechanical Engineering, Adıyaman University, Adıyaman, Turkey (Türkiye)
orcid

Research Focus & Metrics

Academic Career Length

4Years (2023-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 June 2023 in Transactions of the Canadian Society for Mechanical Engineering
Verified
Journal Article
Closed access
KEKaan Emre ENGIN
Kaan Emre ENGIN
AKAli ihsan Kaya
Ali ihsan Kaya
MTMahmut TANDOĞAN
Mahmut TANDOĞAN
There are two major problems with fiber-reinforced polymer (FRP) composites during their machining that need to be addressed. The first concern is the delamination and formation of burrs at machined edges, and the second is the effects of aging leading to mechanical deterioration. In this study, carbon FRP (CFRP) and aramid FRP (AFRP) composites were manufactured by vacuum infusion method and aged for 2 years under natural environmental conditions. Piercing with three different clearances (1%, 5%, and 10% of sheet thickness) and speed of 4 m/s were performed. Additionally, conventional drilling was carried out at a feed rate of 0.2 m/min. The highest delamination factor difference between piercing and drilling processes was calculated as 7.3% and 13.9% for CFRP and AFRP, respectively. The highest burr amounts for AFRP and CFRP composites were obtained as 91.5% and 39% at 10% clearance for piercing process and 123% and 32.1% for drilling process, respectively. Compared with drilling, piercing generates less burr formation except for CFRP composites in the case of 10% clearance and more precise hole production. It is understood that piercing results significantly improve when smaller clearances up to 5% of the sheet thickness are utilized.

27 January 2023 in Processes
Verified
Journal Article
Open access
PDF file
MTMahmut TANDOĞAN
Mahmut TANDOĞAN
OEOMER EYERCIOGLU
OMER EYERCIOGLU
KEKaan Emre ENGIN
Kaan Emre ENGIN
Multi-point forming (MPF) is an advanced and flexible method to form sheet metal workpieces. Although there are studies investigating different aspects of this method, the studies on the effects of pin diameter on sheet and pin contact on MPF are insufficient. In this study, pins with diameters of 10, 12, and 14 mm were used to investigate the damage factor, effective stress distribution, and required forming loads of three forms of aluminum 1100 parts in finite element simulations. In addition, experimental works were conducted for the 12 mm pin and the forming loads and the thinning on the contact points of pin and formed sheet metal parts were compared with the simulations. The 14 mm pin forming provided the highest effective stress distributions and the damage factors of 0.448, 0.770, and 0.329 were obtained for form1, form2, and form3, respectively. The percentage errors between experimental works and simulations using 12 mm pin forming were calculated as 7.4, 5.1, and 2.4% for all forms 1 to 3. In conclusion, pin diameter was shown to have significant effects on the MPF process. Larger diameter pins resulted in higher loads and tearing of sheet metal.