Asmaa Al-Taie

Dr. Asmaa Al-Taie

Institute for Sustainable Industries, Victoria University, Melbourne, Victoria, Australia
orcid

Research Focus & Metrics

Academic Career Length

12Years (2015-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 January 2016 in Procedia Engineering
Verified
Journal Article
Open access
AAAsmaa Al-Taie
Asmaa Al-Taie
MDMahdi M. Disfani
Mahdi M. Disfani
RERobert Evans
Robert Evans
AAArul Arulrajah
Arul Arulrajah
Suksun horpibulsukSuksun horpibulsuk
Suksun horpibulsuk
Subgrades of expansive nature are one of the main causes of damage to road network in Australia. Consequently, lime stabilization has been widely used to reduce the swell- shrink potential of these types of soils and thus reduce the associated damage. After stabilization and compaction, the subgrade will naturally be exposed to cycles of full swell and or partial shrinkage due to climatic cycles. This paper investigates this behaviour for lime stabilized compacted expansive soil from weathered Quaternary Volcanic geological deposits located in Western Victoria; Australia. These soils were stabilized with varying percentages of hydrated lime (2, 3, 4, 6 and 8 percent) and the swell-shrink paths of both untreated and treated soils were studied. Test specimens were compacted at optimum moisture content and maximum dry density. The samples were subjected to full swell-shrink cycles under a surcharge of 25kPa to reach structural stabilization and to simulate the impact of climatic wetting and drying cycles. Vertical deformation and swell-shrink cycle relationships for untreated and treated samples were obtained and analyzed. The results of lime stabilization indicate that equilibrium is reached after three cycles for both untreated and treated samples. In addition, results suggest that maximum deformation occurs in the second swelling cycle. Vertical deformation of untreated sample was reduced to a third after adding 2 percent lime and reduced to a sixth after adding 3 percent lime. The gradient of swelling and shrinkage path reduced to about a sixth and third when it is treated with 2 and 3 percent, respectively. The treated samples reached maximum swelling at a higher degree of saturation than the untreated sample

1 November 2020 in International Journal of Geomechanics
Verified
Journal Article
Closed access
PDF file
AAAsmaa Al-Taie
Asmaa Al-Taie
MDMahdi Disfani
Mahdi Disfani
RERobert Evans
Robert Evans
AAArul Arulrajah
Arul Arulrajah
In practice, it is quite common for soils to be mixed and compacted at moisture contents lower than the optimum moisture content (OMC) or lime content less than the optimum lime content (OLC). This study investigates the effect of not achieving the target of OMC or OLC on the volumetric behavior (swelling and shrinkage) and swelling pressure under swell–shrink cycles. The selected expansive clay was a residual soil derived from weathered Quaternary age basaltic rocks in Western Victoria, Australia. A series of cycles of swell–shrink tests were conducted at different initial lime contents, moisture contents, and stress levels. Vertical deformation and swell–shrink cycles' relationship were obtained and analyzed. The results showed that all specimens tested reached the equilibrium condition after the third swell–shrink cycle. The outcome of investigating the effect of not achieving the target of OLC showed that the maximum swelling occurred on the second cycle changing the degree of expansion from being moderate to very high expansive clay. This result recommended a review of current pavement design procedures to consider the cyclic swell–shrink potential to simulate the field condition for the longer term. However, for investigating the effect of not achieving the target of OMC, the results showed that the maximum swelling occurred at the first cycle, and this suggests that the effect of swell–shrink cycles could be neglected for the long term. This study also showed that at constant moisture content, the swelling pressure decreased as compaction stress decreased; however, at the constant compaction stress, the swelling pressure decreased as moisture content decreased.

23 December 2016 in Road Materials and Pavement Design
Verified
Journal Article
Closed access
AAAsmaa Al-Taie
Asmaa Al-Taie
MDMahdi Disfani
Mahdi Disfani
RERobert Evans
Robert Evans
AAArul Arulrajah
Arul Arulrajah
Suksun horpibulsukSuksun horpibulsuk
Suksun horpibulsuk
Lime stabilisation is a commonly used method for improving the properties of expansive clay subgrades around the world. This paper investigates the effect of curing on the behaviour of lime-stabilised basaltic expansive subgrade. The effect of the presence of low levels of organic material in the surface clay on change in pH of the mixture is also investigated. This leads to a better understanding of the impact of curing duration on the process of lime stabilisation when dealing with these clays. In this study, Braybrook and Whittlesea (a western and a northern suburb of Melbourne, Australia) expansive clays were stabilised using different percentages of hydrated lime. Physical properties of untreated samples and those treated with 2%, 3%, 4%, 6%, and 8% lime were evaluated. A suite of tests was conducted to investigate the behaviour of the stabilised basaltic expansive clay over the curing period and to find the optimum lime content (OLC). These tests included pH concentration at various curing periods (at 1.5 h and at 7, 28, and 57 days), Atterberg limit, linear shrinkage (LS) strain (without curing), swelling potential, and unconfined compressive strength (UCS) (under curing periods of 7 and 28 days). Furthermore, X-ray diffraction (XRD) and scanning electron microscopy (SEM) were conducted on Braybrook soil to investigate the mechanism of soil–lime reaction. The suitability of Eades and Grim [1966. A quick test to determine lime requirements for lime stabilisation. Highway Research Record, 139, 61–72] method in determining OLC is also discussed. Test results of these soils indicated that the longer the curing time, the larger the drop in pH concentration. While the swelling potential results suggest an OLC of 4% (for Braybrook) and 6% (for Whittlesea), UCS tests, plasticity indices, and LS suggest an OLC of 6% for Braybrook soil, while it is about 8% for Whittlesea soil according to UCS tests. However, according to the Eades and Grim (1966) procedure, OLC is about 2.64% and 4% for Braybrook and Whittlesea soils, respectively. This paper suggests a modification of Eades and Grim (1966) method to measure the OLC for basaltic expansive clays to take into account the dropping of pH concentration during curing. The mechanism of lime stabilisation and the analysis of the above tests were the major factors to establish this modification. This modification depends on measuring pH concentration at different lime contents and curing periods. The results contribute to a better understanding of the impact of curing and low levels of organic matters on the stabilisation of expansive clays, which can ultimately lead to a simplified procedure in the determination of OLC.

1 February 2019 in International Journal of Geomechanics
Verified
Journal Article
Closed access
AAAsmaa Al-Taie
Asmaa Al-Taie
MDMahdi Disfani
Mahdi Disfani
RERobert Evans
Robert Evans
AAArul Arulrajah
Arul Arulrajah
Suksun horpibulsukSuksun horpibulsuk
Suksun horpibulsuk
This paper investigates the influence of lime stabilization of an expansive clay based on volumetric behavior and the soil–water characteristic curve (SWCC). The selected soil was a residual clay located in Victoria, Australia. Specimens treated with an optimum lime content (OLC) that was found to reduce swell potential were selected to investigate the SWCCs. Static compaction tests were conducted to establish the virgin compression surface. Hyprop (Meter Group, Pullman, Washington), filter paper, and the chilled mirror hygrometer were used to measure the SWCC at and below the surface at different net stress levels. To interpret the volumetric behavior of untreated and treated soil using the SWCC, swelling and collapse values were measured at various initial moisture contents and stress levels. The test results found that although the treated specimens were stabilized with lime at OLC, significant collapse and swelling potential were obtained when the lime-treated specimens were prepared at high suction value and wetted under low net stresses.

20 August 2023 in Transportation Geotechnics
Verified
Journal Article
Open access
Ehsan YaghoubiEhsan Yaghoubi
Ehsan Yaghoubi
AAAsmaa Al-Taie
Asmaa Al-Taie
MDMahdi Disfani
Mahdi Disfani
SFSam Fragomeni
Sam Fragomeni
MGMaurice Guerrieri
Maurice Guerrieri
EGErnie Gmehling
Ernie Gmehling

1 March 2022 in International Journal of Geomechanics
Verified
Journal Article
Open access
PDF file
Ehsan YaghoubiEhsan Yaghoubi
Ehsan Yaghoubi
AAAsmaa Al-Taie
Asmaa Al-Taie
MDMahdi Disfani
Mahdi Disfani
SFSam Fragomeni
Sam Fragomeni
Sewer infrastructures that are backfilled with available onsite expansive soils may be exposed to damages due to seasonal ground movements. Therefore, for deep excavated trenches located in nontrafficable areas, the suitability of utilizing mixtures of recycled materials as alternative backfilling materials with lower sensitivity to moisture variations was studied. Extensive environmental and geotechnical testing programs were carried out on the performance of four proposed blends comprising different proportions of recycled glass, plastic, and tire aggregates in order to determine an optimum mix design. First, potential environmental hazards of the individual recycled materials were assessed. The investigation was advanced by the development of an application-specific geotechnical testing program utilizing geomechanics theories and methods associated with granular materials. The program included the determination of the maximum dry density achieved using a sand-rain technique (SRT) to simulate the real-life backfilling procedure of excavated trenches, and the determination of the compressibility of the blends using a modified oedometer test. In addition, the potential for the migration of finer particles within the recycled material blends and the possible long-term settlement of the backfilled area were studied. The environmental test results showed that the blends could safely be used as fill materials. The SRT test results revealed that the dry density increased as the moisture content and the height of drop increased and the tire content of the mixture decreased. At moisture contents ≥ 15%, the maximum dry densities obtained through the SRT and the standard Proctor compaction were close, achieving relative densities greater than 80%. Furthermore, by simulating precipitation, inconsiderable segregation of particles was observed in the proposed blends. Based on the results of the developed experimental program, two blends were recommended as the optimum mixtures.