This paper reports a high efficiency uptake of captopril (CPT), employing magnetic graphene oxide (MGO) as the adsorbent. The graphene oxide (GO) was produced through an oxidation and exfoliation method, and the magnetization technique by the co-precipitation method. The nanomaterials were characterized by FTIR, XRD, SEM, Raman, and VSM analysis. The optimal condition was reached by employing GO·Fe3O4 at pH 3.0 (50 mg of adsorbent and 50 mg L−1 of CPT), presenting values of removal percentage and maximum adsorption capacity of 99.43% and 100.41 mg g−1, respectively. The CPT adsorption was dependent on adsorbent dosage, initial concentration of adsorbate, pH, and ionic strength. Sips and Elovich models showed the best adjustment for experimental data, suggesting that adsorption occurs in a heterogeneous surface. Thermodynamic parameters reveal a favorable, exothermic, involving a chemisorption process. The magnetic carbon nanomaterial exhibited a high efficiency after five adsorption/desorption cycles. Finally, the GO·Fe3O4 showed an excellent performance in CPT removal, allowing future application in waste management.
28 March 2018 in Journal of Physics D: Applied Physics
Devices based on spin rectification effects are of great interest for broadband communication applications, since they allow the rectification of radio frequency signals by simple ferromagnetic materials. The phenomenon is enhanced at ferromagnetic resonance condition, which may be attained when an external magnetic field is applied. The necessity of such field, however, hinders technological applications. Exploring spin rectification and spin Hall effects in exchange-biased samples, we were able to rectify radio frequency signals without an external applied magnetic field. Direct voltages of the order of μ V were obtained when Ta/NiFe/FeMn/Ta thin films were exposed to microwaves in a shorted microstrip line for a relatively broad frequency range. Connecting the films to a resistive load, we estimated the fraction of the incident radio frequency power converted into usable dc power.
Magnetic and structural properties of cellulose decorated with magnetite nanoparticles prepared via a co-precipitation method were analyzed. All samples presented magnetisation loops coherent with a superposition of superparamagnetic and ferromagnetic contributions. This feature is attributed to the size distribution of the magnetic nanoparticles and it was observed that weak and demagnetising inter-particle interactions are present. Magnetic parameters like coercivity and remanent magnetisation, however, are mainly governed by the average particle size, and not by such interactions. X-ray diffraction, transmission and scanning electron microscopy were employed for structural investigation, and revealed the presence of magnetite and goethite in some samples.
16 May 2024 in Journal of Physics: Condensed Matter
Magnetic systems with competing anisotropies generally exhibit asymmetry between the maximum amplitudes of the right and left maxima in a magnetoimpedance curve. Small errors in positioning the samples at the experimental setup may also produce such asymmetry. In this work, we present a study on the sources of the asymmetry between magnetoimpedance peaks in systems that present the exchange bias phenomenon, by comparing a phenomenological model to experimental data. A set of samples with different repetitions of the NiFe/FeMn exchange-biased bilayer was used in this study. From the frequency evolution of the asymmetry, together with magnetization curves, we were able to identify the sources for the observed magnetoimpedance asymmetry found on our experimental data.
20 March 2024 in Journal of Physics D: Applied Physics
The potential for technological applications of systems presenting perpendicular magnetic anisotropy is undeniable. With the advent of spintronics and the possibility to explore spin textures, such as skyrmions, in devices, it becomes fundamental to understand how to finely tune the magnetic properties of nanometric systems. In multilayered thin films, characteristics such as domain structure, saturation magnetization and perpendicular anisotropy may be tailored by modifying the interfaces. In the present study, the impact of a copper spacer of varying thickness on the magnetic properties of Pd/Co/Cu/Pd multilayers is investigated. The evolution of magnetization curves, domain patterns and magnetization reversal processes in terms of the spacers thickness are analyzed.