The use of renewable energy system (RES) is increasing rapidly. However, it is still difficult to measure the environmental impact of renewable energy system. This study aims to develop a general environmental indicator which is able to reflect all the aspects of environmental impacts of a RES. The life cycle assessment (LCA) and fuzzy logic is used to develop an environmental indicator to assess all the environmental impacts. The five important environmental indicators are selected based on LCA standard: Abiotic Depletion Potential, Land Use, Climate Change, Photochemical Ozone Creation Potential and Acidification Potential. Fuzzy inference system is used to convert the original values of these indicators into fuzzy data and aggregate them into the general indicator. The computed fuzzy value of the general indicator is then defuzzified into a crisp number as the final indicator value of environmental impacts
This paper presents a control scheme for a photovoltaic (PV) system that uses a single-phase grid-connected inverter with low-voltage ride-through (LVRT) capability. In this scheme, two PI regulators are used to adjust the power angle and voltage modulation index of the inverter; therefore, controlling the inverter’s active and reactive output power, respectively. A fuzzy logic controller (FLC) is also implemented to manage the inverter’s operation during the LVRT operation. The FLC adjusts (or de-rates) the inverter’s reference active and reactive power commands based on the grid voltage sag and the power available from the PV system. Therefore, the inverter operation has been divided into two modes: (i) Maximum power point tracking (MPPT) during the normal operating conditions of the grid, and (ii) LVRT support when the grid is operating under faulty conditions. In the LVRT mode, the de-rating of the inverter active output power allows for injection of some reactive power, hence providing voltage support to the grid and enhancing the utilization factor of the inverter’s capacity. The proposed system was modelled and simulated using MATLAB Simulink. The simulation results showed good system performance in response to changes in reference power command, and in adjusting the amount of active and reactive power injected into the grid.
1 June 2024 in International Journal of Power Electronics and Drive Systems (IJPEDS)
Due to the increased demand for electrical energy, many countries were prompted nowadays to search for new sources. One important source is the photovoltaic energy. However, despite the great benefits of this source, some defects where observed when linking to distribution networks (negative impact on the protection system). Hence, an approach of improving the protection system in distribution networks integrated with photovoltaic cells is presented in this paper. The protection system improvement is proposed by changing the impedance to resistance ratio (X/R) values of the networks cables, which leads to increasing the overcurrent relays' response speed when a fault occurs. A comparative analysis with different cable reactance values was conducted. The electrical transient analyzer program (ETAP) software was used to investigate and validate the effects on the relay’s response times. Amriya Fallujah power station, located in Iraq, was investigated as a case study. Simulation results show that it is possible to increase the response speed of the overcurrent relay by reducing X/R of the network cables. For more validation, the distance relay was used to compare the best improvement results of changing the X/R ratio with the results of changing the type of relay, which also shows the strength of the proposed method.
1 January 2019 in International Journal of Energy Economics and Policy
This article presents simulation study on using fuzzy logic based controllers in order to determine building's occupancy level and hence its effect on energy usage. The projected results of energy savings then is used to determine and investigate the proposed fuzzy logic based control system environmental and economic aspects. The proposed system energy performance are measured based on the system occupancy density level, Daylight utilization and natural ambient air and humidity. The simulation and modelling engines used in this article are MATLAB and EnergyPlus. Results showed that system will save 14% of total energy demand at 50 % of occupancy level compared to total energy demand at full occupancy level (100% occupancy level) and also it is able to save 24% of total energy demand at 25 % of occupancy level compared to full occupancy level energy demand (100% occupancy level).Keywords: Daylight, Occupancy level, Fuzzy logicJEL Classifications: K32, O13DOI: https://doi.org/10.32479/ijeep.6393
15 March 2020 in International Journal of Energy Economics and Policy
The objective of this article is to provide an efficient means of enforcing green building in Jordan, the Middle East. The paper is proposing assessment tool of Energy Star Rating Scheme and also explaining its role for achieving sustainable development during buildings lifecycle and hence reducing energy and water usage. The Scheme development will remove considerable environmental, social and economic issues as Jordan is a country that renowned for its poor energy and water resources. The article provides technical aspects, means, technologies and processes for proposing and implementation Green star ratings for buildings. The star ratings are based on integrating renewable energy technologies, water recourses and its consumption management and waste recycling and its management throughout the buildings’ life cycle including its design, installation and operation. Keywords: Energy star ratings, Energy and water, Sustainable energy, Environment JEL Classifications: K32, O13 DOI: https://doi.org/10.32479/ijeep.7982