A novel compact fractal loaded two- and eight-element multiple input multiple output (MIMO) with strong diversity is designed for 5G Sub 6 GHz and WLAN applications. The suggested antenna is designed and manufactured on inexpensive FR4 dielectric material with small size of 72 mm × 72 mm × 1.6 mm (0.792λ × 0.792λ × 0.0176λ, where λ is calculated at a lower operating frequency). The proposed layout features a partially grounded, protruding T-shaped stub on the underside of the substrate and a set of fractally loaded circular patch antenna elements on the top. Four triangular slots on the substrate and a T-shaped stub on the ground are employed to produce good isolation over the intended bands. The proposed antenna has a frequency range of (3.3–6.0) GHz, making it compatible with the 5G sub-6 GHz bands and the WLAN band thanks to its high isolation of above 15 dB and good impedance matching characteristics. Good agreement is observed between the antenna results and the theory of characteristic mode analysis approach. The designed antenna is well suited for 5G sub-6 GHz and WLAN communication applications due to its low ECC (0.005), total active reflection coefficient (TARC) (−10 dB), mean effective gain (MEG) (−3 dB), and diversity gain (DG) (−10 dB), channel capacity losses (CCL) (0.05), peak gain (>2.5 dBi), radiation efficiency (>95%), and stable boresight radiation patterns.

A novel compact-slotted four element multiple input multiple output (MIMO) planar monopole antenna is proposed for 5G mmWave N257/N258 and N262 band applications. The antenna, with dimensions of 12 mm × 11.6 mm × 0.508 mm ($1.036{\lambda }_o \times$$1.001{\lambda }_o\times 0.043{\lambda }_o$ where ${\lambda }_o$ is computed at lowest cutoff frequency), is fabricated on a Rogers RT/duroid 5880 (tm) substrate with a relative permittivity of 2.2 and a dielectric loss tangent of 0.0009. The suggested antenna consists of four U-shaped radiating elements (patches) on top of the dielectric material and a slotted ground on the bottom. The radiating elements are fed by a 50-ohm microstrip line feed. To improve the impedance performance of the MIMO antenna, a rectangular strip of 1.3 mm × 0.2 mm and a couple of rectangular slots are added to each radiating element. The first operating band at 27.1 GHz, ranging from 25.9 GHz to 27.8 GHz, is achieved by using slotted U-shaped radiating elements. The second operating band at 48.7 GHz, ranging from 47.1 GHz to 49.9 GHz, is obtained by etching hexagonal slots on the ground. The antenna design achieves an isolation of >27 dB through the orthogonal positioning of radiating elements and slots on the ground. The designed antenna operates at 27 GHz (N257/N258) and 48.7 GHz (N262) bands, exhibiting stable radiation patterns, a peak gain of >5.95 dBi, radiation efficiency of >90%, an envelope correlation coefficient of <10⁻⁶, a total active reflection coefficient of ≤−10 dB, channel capacity losses of <0.03 bits/s/Hz, and a mean effective gain of ≤−3 dB. The simulated and measured results of the antenna show good agreement, making it well-suited for 5G mmWave communication applications.

The current and future wireless communication systems demand for higher data rates, enhanced quality of service and more channel capacity. Since Federal Communications Commission (FCC) allocated the unlicensed frequency spectrum from 3.1 to 10.6 GHz for commercial applications in the year 2002, Ultra-Wideband (UWB) technology has attained considerable attention because of its inherent features like high data rate, more channel capacity, extremely less power consumption and low cost. However, for UWB systems, multipath fading and frequency interference are the two significant issues that requires further investigation. In recent times, Multiple Input Multiple Output (MIMO) technology has gained much attention in wireless communication as it exploits multipath to increase the communication range and link quality. Thus, MIMO technology is a promising solution for mitigating multipath fading in UWB system. However, accommodating multiple antennas with less mutual coupling between them in portable devices is always a challenging task for antenna designers. UWB system could easily interfere with existing narrowband communication system such as Wireless Local Area Network (WLAN). So, the design of an ultra-wideband antenna with integrated frequency notching function is a good solution to suppress the frequency interference and to reduce the complexity of the UWB system instead of using a conventional filter. In this chapter, compact isolation-enhanced planar UWB-MIMO antenna with single band-notched characteristics is presented.