Triaxial tests were employed to investigate palm-fiber-reinforced sand under consolidated drained conditions in this study. Sixteen series of triaxial tests were carried out to investigate the properties of palm-fiber-reinforced sand. One series of pure sand was also employed for comparison. The deviator stress, stress path, shear strength, volume change, void ratio, and enhanced coefficient of fiber-reinforced sand were studied with different fiber lengths varying from 8 mm to 20 mm and fiber contents varying in mass from 0.3% to 0.9%. The test results indicate that palm fibers were beneficial for enhancing the shear strength of the sand. Compared to the peak shear strength increase of about 10% to 20%, the critical shear strength increased much more, by a little over 100%. Therefore, the fibers played a key role in enhancing the critical shear strength of the sand but not the peak shear strength of the sand. The addition of fiber to sand resulted in prolongation of the axial strain required to reach the critical void ratio and improved the sand’s ability to resist larger deformations, enhancing its toughness. Furthermore, the critical shear strength of the sand was positively correlated with both fiber content and fiber length, and the axial strain required to reach the critical shear strength increased with increasing fiber content and length. This study provides valuable experimental data and serves as a reference for temporary reinforcement in geotechnical engineering.

Sixteen Reduced Triaxial Compression (RTC) triaxial tests were conducted to investigate the reinforcement effect of fibered clay in this paper. Palm fiber with four different fiber lengths (5 mm, 10 mm, 15 mm, and 20 mm) and four different fiber contents (0.3%, 0.5%, 0.7%, and 0.9% in mass) were utilized. Accordingly, three additional groups of triaxial tests were performed to analyze the stress path effects with four different stress paths, including RTC, Conventional Triaxial Compression (CTC), Reduced Triaxial Extension (RTE), and isotropic Triaxial Compression (TC). Three samples were tested, including fibered clay with a fiber length of 10 mm and a fiber content of 0.7% (referred to as 10 mm 0.7%), fibered clay with a fiber length of 20 mm and a fiber content of 0.5% (referred to as 20 mm 0.5%), and bare clay, which was used to reveal the fiber reinforcement of clay. All samples were tested under consolidated undrained conditions. The test results showed that in RTC conditions, the deviator stress increased to a greater extent with 0.3% mass content of fibers according to the same higher confining pressures of bare clay. Fibers primarily increased the cohesion of fibered clay, a shear strength parameter, in terms of total stress, whereas they also increased the friction angle of fibered clay in terms of effective stress. For short fibers, the coefficient of strength reinforcement of the fibered clay increased with fiber content. However, for long fibers, this reinforcement may lead to a weakening of the clay’s strength, as the long fibers may cluster or weaken along their longitude. Among the four stress paths (CTC, TC, RTC, and RTE) examined, the reinforcement took effort mainly in the CTC condition. In contrast, in unloading conditions, the fibers had little contribution to reinforcement. Consequently, in unloading conditions, such as deep excavating and slope cutting, the stress path should be considered to obtain a reliable parameter for geotechnical engineering applications.