The paper deals with the analysis of simulated data, where thousands of samples of reflections from a radar target, a helicopter, with propellers were simulated. Simulations were performed for helicopters with 3, 4, 6, and 8 propeller blades. Data collection and evaluation were focused on the measurement of the Doppler Effect, specifically the Micro-Doppler effect for the rotating propeller section. The simulations have been divided into several sections for all types of helicopters differing in the number of propellers. The most considered was the change of Radar Cross Section (RCS), but changes in helicopter movement speed, changes in helicopter position relative to the radar, and changes in helicopter rotation speed have been considered as well. Moreover, a simulation of the change in radar carrier frequency across the microwave band was performed and the changes and effects on the Micro-Doppler measurement data were studied. However, the main task of this paper was to determine the number of propeller blades from any simulated signal sample with parameters corresponding to the Micro-Doppler, which was successfully done. Simulated data has been used to train a deep learning network to classify the number of propeller blades on a randomly selected measured/simulated sample. To detect the number of rotors, we have chosen to use Convolutional Neural Networks (CNN), which achieve good results for object recognition from images.
In this paper we present a reduced complexity digital predistortion of multiple power amplifiers. The reduction is based on using only one feedback path taking into account the similar characteristics of amplifiers in the MIMO system. After some theoretical basics, the paper presents the results of the experiment trying to give an answer whether the predistortion can be used with limited (in extreme case with only one) number of feedback paths. Due to its very low out-of-band emissions, the filter-bank-multicarrier signal has been used as a test signal as a typical representative of post-OFDM waveforms.
This paper presents a method for estimating the position of a target under jammed conditions using the Time Difference of Arrival (TDOA) method. The algorithm utilizes a deep neural network to overcome the challenges posed by the jammed conditions. The simulations and results indicate that the presented method is more accurate and efficient than the traditional TDOA methods.
Novel multicarrier waveforms, such as, Filter Bank Multi Carrier promise lower out-of-band emissions compared to the currently used Orthogonal Frequency Division Multiplex technique. Unfortunately, the power amplifier nonlinearity in the transmitter can significantly degrade the FBMC spectrum wiping-out the differences between these two approaches. In order to compensate for nonlinearities and memory effects introduced by power amplifiers, the digital predistortion is a widely used technique, but also the predistortion itself can significantly be influenced by the transceiver imperfections. This paper thus laid great emphasis on the evaluation of transceiver imperfections and uncertainties on the overall performance of digital predistortion driven with FBMC signals.
We consider the problem of periodic nonuniform sampling of a multiband signal and its reconstruction from samples in the feedback path of a digital predistortion system in order to decrease the sampling rate, hence to increase the bandwidth of digital predistortion system. Such considerations are particularly important in context of the wideband multiband linearization system design.